User manual TOTAL GYM GTS

[. . . ] GTS® OWNER'S GUIDE OWNER'S GUIDE 800 541 4900 GTS ® EFISPORTSMEDICINE. COM CONGRATULATIONS Thank you for purchasing GTS®, the center of the GRAVITYSystem® and anchor for the comprehensive GRAVITY4Programming®. Your GTS is an investment that will enhance your business year after year. Please read and save your Owner's Guide so that you may refer to it in the future. Your GTS® arrives with very little required in the way of assembly. [. . . ] Whenever you move or store the GTS, fold the Telescoping Squat Stand (H) and Folding Platform (I) toward the Glideboard (G). Pull the Folding Platform (I) left side retractable pin (as you face the Tower (A) while pushing the Telescoping Squat Stand (H) forward until the retractable pin locks in place in the folded position against the Glideboard (G). Pull the Folding Foot Holder (E) knob on the inside of the right rail to rotate the Folding Foot Holder (E) to the down position. Attach the center pulley snap hook (located on the Dynamic Arm Pulley System (W)) to the lock pin bracket located on the Support Strut (O). The pulley and cable will be underneath the padded Center Rail Crossbar (U). Lower the LAT Bars (Y) to the folding position (parallel to the rails). Next, adjust the Pulley Locater Brackets (X) to the fourth position on the LAT Bars (Y). Lower the Rails (K, N) to the lowest level. With one hand on the Tower (A) and one hand on the Upper Rail (N), disengage the Rails (K, N) from the Tower Hooks (R) and lower the Rails (K, N) slowly towards the Tower Base (Q). While holding the Tower (A), unscrew and disengage the Support Strut Knob (M) by pulling it out. HINT: Rock the Tower (A) backward to help release tension on the Support Strut Knob (M). Once the Support Strut Knob (M) has disengaged, pull the Tower (A) forward to its full, upright position. IMPORTANT: Disengage the Support Strut Knob (M) during folding to avoid damage to your GTS. 61 62 62. 66. NOTE: Letters in (parentheses) refer to the PARTS IDENTIFIER on page 3 and/or the PARTS ASSEMBLY on page 4. Use as needed for clarification. GTS® OWNER'S GUIDE FOLDING AND STORAGE (CONTINUED) 67. While continuing to hold the Tower (A), grasp either side of the padded Center Rail Crossbar (U). While continuing to hold both the Tower (A) and either side of the padded Center Rail Crossbar (U), move into position to pull the Rails (K, N) up and towards the Tower (A). hold 67 68 69 69. Pull the Rails (K, N) up and toward the Tower (A) until the rails form an A-frame. 70 71 72 OWNER'S GUIDE GTS ® 73. Insert the Tower Lock Pin (D) to secure the GTS in the upright position. Check to make sure the Support Strut Knob (M) has re-engaged and screw in the Support Strut Knob (M). Hang the Handles (T) out of the way and make sure the Dynamic Arm Pulley System (W) remains free from contact with the center hinge, floor or Transport Wheels. To unfold the GTS and return it to use, follow the unfolding directions at the beginning of this guide. 73 74 TO MOVE THE THE GTS 74. Stand behind the Tower (A), grasp the Tower Top Handle (B) and lean the Tower (A) back toward you. [. . . ] Also covered by one or more of the following patents: D493, 853; D405, 132; 4, 004, 801; 5, 169, 363; 5, 967, 955. LIMITED WARRANTY GTS ® Subject to the exclusions and other terms and conditions set forth below, Engineering Fitness International Corp. ("EFI") warrants the following components to be free from defects in materials and workmanship under normal usage for the period(s) specified below. This limited warranty is your exclusive remedy and applies to new products purchased in the United States, which are accompanied by this written warranty. EFI, at its option, will repair, replace or refund the purchase price of any product that does not conform to this warranty. [. . . ]