User manual TOYOTA SL1SL1T

[. . . ] HowtoChangeThreads The machine is supplied with thread but the following is an easy way to change them: (1) Cut the thread in use near the cone spool (behind the telescopic thread stand). (3) Set tensions to "0" so that the thread knot can pass through smoothly, draw out the looper thread until the thread knot comes to about 10 cm past the presser fool. (4) When changing the needle thread, cut off the thread knot before it reaches the eye of the needle to avoid bending the needle as the knot is pulled and caught in the needle's eye. To make the above threading easier, use tweezers. [. . . ] Cut the thread leaving about 10cm (4") of spare thread. Confirm that the upper knife moves against the lower knife correctly by turning the handwheel slowly towards you. If it is not correct, check if there is any fabric or waste thread between knives. Turn the handwheel towards you with your right hand to check that the thread winds around the stitch finger of the needle plate. If the thread doesn't wind around the stitch finger of the needle plate, check if any threads are threaded incorrectly. FOURTHREADOVEREDGING STITCHUSING2NEEDLES BeforeSewing After threading is completed, and when the threads are not wound around the stitch finger, gently draw out the four threads under and behind the presser foot, and turn the handwheel towards you by hand two or three times to make the thread wind on to the needle plate. For setting average material, there is no need to lower the presser foot lifter. When beginning to sew, push the material just in front of the presser foot and it will be fed through. For the thick material, lower the presser foot lifter, place the material under the presser foot, then raise the presser foot lifter. BeginningandEndingofSewing Beginningtosew Just put your left hand on the material to push it slightly until the tip of the fabric comes exactly behind the presser foot. Make chain-stitches at the end of the sewing to prevent the thread from untying and to prepare for the next sewing. Draw the finished fabric gently backwards and to the left as the machine is operating and make chain-stitches. Then cut the thread 2 ~ 5cm (1-2") from the presser foot. Do not pull it out roughly as the needle will bend and break. Adjustment is necessary only when you work on very thin or very thick materials. Accordingly, sew thinner materials with less pressure and thicker materials with more pressure. Increase the pressure of the presser foot by tightening the adjustment screw. Balance of the Loopwer thread: When the lower looper thread is pulled to the top of material, loosen tension dial counterclockwise. Adjust the size of the bight from 5 mm (0. (1) If the cutting width is narrower than the bight size, turn the bite width adjusting dial to the direction of arrow. [. . . ] Vite del coltello ìnferìore Allineare Placca ago Coltello inferiore Coltello superiore Placca ago Posizione più bassa Coltello inferiore. CHANGING THE LIGHT BULB When the light does not come on even though it is switched on: (1) Take out the power supply plug. LUBRICATION Lubrication is not necessary for this machine since the important parts are all made of a special oil impregnated sintered metal. However, one or two drops of oil will increase durability. [. . . ]