User manual TOYOTA SUPER JEANS

[. . . ] SP100 Series HOME-USE SEWING MACHINE •• Read this manual carefully before use and always follow the instructions. €• Keep the manual in a convenient place for easy reference. €• If you give the sewing machine to someone else, also give them this instruction manual. INSTRUCTION MANUAL Contents 1 Before use (Be sure to read this section before use) •• •• •• •• •• •• Important safety instructions. [. . . ] Face the flat surface of the needle to the rear and insert until it makes contact with the pin. Firmly tighten the needle clamp screw with the screw driver for the needle plate. Pin Screw driver for the needle plate Needle clamp screw Flat surface zz Correct needle selection Good needle If a faulty needle is used, not only could it impair the sewing performance, but it could also damage the needle plate or hook, or break the needle. ** Incorrect stitching or thread breaking, try replacing the needle. ÍFaulty needle The entire needle is bent 26 The point of the needle is crushed / worn away The point of the needle is bent Relationship between the needle, thread and fabric, and adjusting the thread tension The quality of the sewing finish will improve if the needle and thread are changed to match the type of fabric. Follow the directions in the table below. € Please purchase any needles not included as accessories, after checking they are specified as home-use sewing machine needles. € Use the same kind of threads for upper/lower thread. € The bigger the needle number is , the thicker the needle is, the bigger the thread number is, the thinner the thread is. • Normally , sew with the upper thread tension dial set to “ XXX15D/SuperJ15). € (for XXX15C) / “ ” (for 27 + 1 + - 1 -1 3 +2 +1 3 Sewing Caution Do not pull the fabric excessively while sewing. Doing so could break the needle and cause an injury. Straight stitching and reverse sewing zz Straight stitch 1 1 2 Turn the handwheel towards yourself to raise the needle. Turn the pattern selection dial to choose the pattern. Zigzag sewing foot (Originally attached to the sewing machine) 7 8 9 4. 0 mm (For details on changing the presser foot, refer to “Changing the presser foot” on page 24. ) 1 Position the fabric and lower the presser foot lever. Step on the foot controller to begin sewing. Zz End of sewing After sewing, turn handwheel towards yourself until the needle is in the highest position. Raise the presser foot and pull out the fabric to the rear. 28 zz Thread cutter „„For model XXX15C Line up the two threads, and cut them with the thread cutter on the presser bar. Thread cutter „„For model SuperJ15 Line up the two threads, and cut them with the thread cutter on the face cover. [. . . ] No grounding means are provided on a double-insulated product nor should a means for grounding be added to the product. Servicing a double-insulated product requires extreme care and should only be done by qualified service personnel with knowledge of the system under his or her responsibility. Replacement parts for a doubleinsulated product must be identical to those parts in the product. The symbol is marked on the double-insulated product. [. . . ]