User manual TP-LINK MA180

[. . . ] MA180 3. 75G HSUPA USB Adapter Rev: 2. 0. 0 1910010681 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. Copyright © 2012 TP-LINK TECHNOLOGIES CO. , LTD. [. . . ] Then the matched messages will be displayed in the 4. 2. 3 View a Message To view a message, follow the steps below: 1. The name and phone number of the message sender, message content and receiving time will be displayed below the message list. The message can’t be managed by right-clicking it. Please make use of the icons displayed above the message list for the following options: : Delete the selected message. : Re-edit the content of the selected message. : Reply to the sender of the selected message. : Forward the selected message to other recipients.  Note: 1. You can press and hold the Ctrl or Shift and then click the selected messages. You can also press Ctrl + A to select all the messages in the list. Then you can click on the icon delete the selected messages at the same time. If you choose to delete a message, it will be deleted permanently. Therefore, be cautious while doing this. You can forward only one message at a time. 4. 2. 4 Message Settings You can set visual and audio prompt as well as save mode for the received messages. Click on the icon , and then click the Message button to display the interface as shown in Figure 4-4. 15 MA180 3. 75G HSUPA USB Adapter User Guide Figure 4-4 4. 2. 4. 1 Alert Settings You can set visual and audio prompt for the received messages in the Text message handling area.  Show a notification when a new text message arrives With this item checked, when a new message arrives, a dialog box read “New message in!” will appear on the lower-right corner of your computer screen for about three seconds and then disappear. Meanwhile the icon will appear at the bottom of the utility interface. Click the words or go to the message interface to view the new message.  Play a sound when a new text message arrives With this item checked, the selected tone will be played when a new message arrives. To select a tone file, follow the steps below: 1. Type the path and file name of the tone file into the “Sound file name” field or click the Browse button to locate a tone file. Click Test to play the tone; click Stop to stop playing the tone. 4. 2. 4. 2 Save Mode Settings You can specify a location to save the received messages in the New Message Save Mode area. When a new message arrives, it will be saved in the specified location. [. . . ] Click OK. 23 MA180 3. 75G HSUPA USB Adapter User Guide Figure 4-12 To disable it again, follow the steps below: 1. Choose Disable Pin form the drop-down list, as shown in Figure 4-13. Click OK. 24 MA180 3. 75G HSUPA USB Adapter User Guide Figure 4-13 4. 5. 2. 2 Verify the PIN Code With PIN protection enabled, you need to enter the PIN code when starting the utility again, as shown in Figure 4-14. Enter the correct PIN code and then click OK to use the Adapter. 25 MA180 3. 75G HSUPA USB Adapter User Guide Figure 4-14 If you click the Cancel button before entering the PIN code, follow the steps below to verify the PIN protection. [. . . ]