User manual TP-LINK RTR ARCHER C60

[. . . ] Protect the Network from Cyber Attacks . Share Local Resources on the Internet by Virtual Servers . Se the WPS Wizard for Wi-Fi Connections . The Quick Installation Guide instructs you on quick Internet setup, and this guide provides details of each function and shows you the way to configure these functions appropriate to your needs. [. . . ] If your ISP provides the networking service based on IGMP technology, e. , British Telecom(BT) and Talk Talk in UK: 1 ) Tick the IGMP Proxy checkbox and select the IGMP Version, either V2 or V3, as required by your ISP. 53 Chapter 11 Customize Your Network Settings 2 ) Click Save. 3 ) After configuring IGMP proxy, IPTV can work behind your router now. You can connect your set-top box to any of the router’s Ethernet port. If IGMP is not the technology your ISP applies to provide IPTV service: 1 ) Tick Enable IPTV. 2 ) Select the appropriate Mode according to your ISP. €¢ Select Bridge if your ISP is not listed and no other parameters are required, and then skip to Step 4. €¢ Select Custom if your ISP is not listed but provides necessary parameters. 3 ) After you have selected a mode, the necessary parameters are predetermined. Enter the IPTV Multicast VLAN ID and select the IPTV Multicast VLAN Priority in Russia mode according to your ISP. 4 ) For Russia, Singapore-ExStream, Malaysia-Unifi and Malaysia-Maxis mode, connect the set-top box to the predetermined LAN port. For Bridge and Custom mode, select the LAN type and connect the set-top box to the corresponding port. You may need to configure your set-top box before enjoying your TV. Tips Qos and IPTV cannot be enabled at the same time. Specify DHCP Server Settings By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices from the IP Address Pool. You can change the settings of the DHCP Server if necessary, and you can reserve LAN IP addresses for specified client devices. Net, and log in with the username and password you set for the router. ¾¾ To specify the IP address that the router assigns: 1. Make sure that the Enable DHCP Server checkbox is selected. Enter the starting and ending IP addresses in the IP Address Pool. Enter other parameters if the ISP offers, the Default Gateway is automatically filled and is the same as the LAN IP address of the router. [. . . ] 3 ) If it continues to show note of Network Security Key Mismatch, it is suggested to confirm the wireless password of your wireless router. note: Wireless Password/Network Security Key is case sensitive. €¢ Windows unable to connect to XXXX / Can not join this network / Taking longer than usual to connect to this network: • • • Check the wireless signal strength of your network, if it is weak (1~3 bars), please move the router closer and try again. Change the wireless Channel of the router to 1, 6, or 11 to reduce interference from other networks. [. . . ]