User manual TP-LINK SL2226P+

[. . . ] COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK Technologies Co. , Ltd. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK Technologies Co. , Ltd. [. . . ] As figure 5-11. - 14 - TL-SF2226P+/TL-SL2226P+ Remote Smart Switch User Guide Figure 5-11 Current VLAN mode is shown in the combo box, select one mode you want in the combo box and click OK. If you change the VLAN mode, the information of previous VLAN will be lost and the switch will give new default information about VLAN. If the VLAN mode is port VLAN, all ports will be in a VLAN. If the VLAN mode is tag VLAN, all ports will be in a VLAN which tag's value is 1. After Configuring VLAN mode, you can configure VLAN now. Click main menu->Config->VLAN Config, under the view, you will see the VLAN list box. Double click the VLAN you wan to change. If the VLAN mode is port VLAN, select or delete some ports you want to change in the pop-up dialog. As figure 5 -12. Figure 5-12 If the VLAN mode is tag VLAN, Configure tag VLAN in the pop-up dialog. For more details, please read the help file. - 15 - TL-SF2226P+/TL-SL2226P+ Remote Smart Switch User Guide Figure 5-13 Now go back to the main menu->Config->VLAN Config->Config Effect, Only execute this step, the Configuration will be valid. If the VLAN mode is not changed, this menu can't be seen. TRUNK Config TRUNK can transmit net data through a group of ports. The switch looks a TRUNK as a big port regardless of it's composition. Default setting: no TRUNK. Steps of setting: Click main menu->Config-> TRUNK Config->Config Effect or click the TRUNK icon on toolbar. As figure 5-14. Figure 5-14 Double click the TRUNK you want to config in the TURNK list box, TRUNK configuration dialog will pop up, and you can config the TRUNK now. For more details, please refer to - 16 - TL-SF2226P+/TL-SL2226P+ help file. Remote Smart Switch User Guide Now go back to main menu->Config->TRUNK Config->Config Effect. Figure 5-15 Only execute this step, the Configuration will be valid. If the TRUNK is not changed, this menu can't be seen. Port Config Click main menu->Config->Port Config or double click a port in the port list box. As figure 5-16. Figure 5-16 Now you can configure each parameter of the port except port priority. 1) Mode: 10Base-T/100Base-TX Ports Auto (default): other end. auto-test the speed and negotiate the duplex mode with the - 17 - TL-SF2226P+/TL-SL2226P+ 10HD: 10Mbps, Half-Duplex. 100FD: 100Mbps, Full-Duplex 2) Flow Control: Remote Smart Switch User Guide Disable: The port won't produce Flow Control packets and will discard the Flow Control packets received. [. . . ] If you input a valid IP or gateway, you will get an error message. If you want to save the configuration, press ctrl + s and the switch will restart. Make sure that the network configuration is correct before you save it. If you don't want to save it, press Esc to quit. - 31 - TL-SF2226P+/TL-SL2226P+ 3) Factory Reset Remote Smart Switch User Guide This operation will lead to factory set of the switch. [. . . ]