User manual TP-LINK TD-W8970N

[. . . ] TD-W8970N Wireless N ADSL2+ Modem Router Rev: 1. 0. 0 1910010221 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO. , LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. [. . . ] 6. 45 TD-W8970N Wireless N ADSL2+ Modem Router User Guide 4. 4. 7. 2 URL Filter This section allows you to configure the filter rules based on URL to control the computers in the LAN to access the specified port. Figure 4-40 There are two policies for the URL Filter. Exclude: Block the PCs to access the specified URL. Include: Only allow the PCs to access the specified URL. To add a URL Filter entry for Parental Control rule: 1. Check the Exclude or Include radio button. Click the Add button in Figure 4-40 and then you will see the next screen as shown in Figure 4-41. Enter the URL Address and Port Number. Figure 4-41 3. Click Save/Apply to save this entry and then you will see your settings as shown in Figure 4-40. 4. 4. 8 Quality of Service Choose "Advanced Setup" "Quality of Service", you can enable QoS (Quality of Service) on the screen shown in Figure 4-42. QoS helps to prioritize data as it enters your router. By attaching special identification marks or headers to incoming packets, QoS determines which queue the packets enter, based priority. This is useful when there are certain types of data you want to give 46 TD-W8970N Wireless N ADSL2+ Modem Router User Guide higher priority, such as voice data packets give higher priority than Web data packets. This option will provide better service of selected network traffic over various technologies. Figure 4-42 Select the Enable QoS checkbox to enable all QoS for all interfaces. Select a Default DSCP make from drop-down list to automatically mark incoming traffic without reference to a particular classifier. Click Save/Apply to save the current configuration. Note: The default DSCP mark is used to mark all egress packets that do not match any classification rules. 4. 4. 8. 1 Queue Config Choose "Advanced Setup" "Quality of Service" "Queue Config", you can set up virtual servers on the screen below. Figure 4-43 Click the Add button in Figure 4-43, and you can configure the QoS queue entry on the next screen as shown in Figure 4-44. 47 TD-W8970N Wireless N ADSL2+ Modem Router User Guide Figure 4-44 Name: Set a name for the entry. Enable: Select Enable option to take this entry effect. Interface: Assigned a specific Wan Service for this QoS queue entry. Precedence: Specify precedence for this QoS queue entry. DSL Latency: Select latency path for the type of data transmission, only Path0 is available for this Router. After you specify the condition, click Save/Apply to save the entry and then you will see you settings as shown in Figure 4-43. Note: 1) 2) Lower integer values for precedence imply higher priority for this queue relative to others. [. . . ] Server - Any computer whose function in a network is to provide user access to files, printing, communications, and other services. SOHO (Small Office/Home Office) - Market segment of professionals who work at home or in small offices. SSID - A Service Set Identification is a thirty-two character (maximum) alphanumeric key identifying a wireless local area network. For the wireless devices in a network to communicate with each other, all devices must be configured with the same SSID. [. . . ]