User manual TP-LINK TL-PA201

[. . . ] TL-PA201 200Mbps Powerline Ethernet Adapter Rev: 1. 0. 0 1910010103 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO. , LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. [. . . ] In most cases, only one device will display in this panel. Click and select the local device shown on the screen then click "Connect" tab to manage the Ethernet Powerline Adapter. The status message will be shown above the "Connect" button indicates that your PC is connected to the same device. Once the chosen Ethernet Powerline Adapter is properly connected, this Management Utility will automatically scan the power line periodically for any other existing powerline devices. "x" Powerline Devices detected: This display all the Ethernet Powerline Adapter found on the current logical network. "x" shows the number of remote Ethernet Powerline Adapter discovered by this Management Utility. Network Type: Displayed the type of logical network: "Public" or "Private". Autoscan: Shows the scanning status (Default is "ON"). Device Name: Shows the default device name. One may redefine or change the name by clicking on the name and editing in place or by clicking the "Rename" button. Password: Shows the current password of the Ethernet Powerline Adapter. Quality: Shows the quality of the Ethernet Powerline Adapter connection. Rate (Mbps): Shows the current transmission rate of the selected Ethernet Powerline Adapter. MAC Address: Shows the Ethernet Powerline Adapter's MAC address. Rename: Click to change the name of the selected Ethernet Powerline Adapter. Enter Password: Shows the supplied Ethernet Powerline Adapter's password (Initially left blank). To set the Ethernet Powerline Adapter password (Which is required when creating a private network), click and select the device shown in the lower panel and click on the "Enter Password" button. Follow the pop-up dialog box to complete your password setting. Add: Click this button to add a remote Ethernet Powerline Adapter to your network that is not on the lower panel displayed list. You will advice to locate the passwords for all Ethernet Powerline Adapter 9 TL-PA201 200Mbps Ethernet Powerline Adapter you wish to manage and add them to the local logical network by clicking the "Add" button. Follow the pop-up dialog box to complete your setting. Scan: Click the "Scan" button to perform an immediate search of the Ethernet Powerline Adapter connected to the computer. [. . . ] Now Powerline adapter A, B and C are connected. Step 2. Step 5. 5. 3 Pair Button Behavior The following table summarizes the actions that occur when the Pair button is pressed for specific time. Pair button Action Status The adapter joins a network. It shares the same network name as other adapters on the Powerline network. [. . . ]