User manual TP-LINK TL-R860

[. . . ] TL-R860 Cable/DSL Router Rev: 1. 0. 2 1910010010 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. Copyright © 2009 TP-LINK TECHNOLOGIES CO. , LTD. [. . . ] Incoming Ports Range - The port or port range used by the remote system when it responds to the outgoing request. A response using one of these ports will be forwarded to the PC that triggered this rule. You can input at most 5 groups of ports (or port section). Every group of ports must be set apart with ", ". For example, 2000-2038, 2050-2051, 2085, 3010-3030. Incoming Protocol - The protocol used for Incoming Ports Range, either TCP or UDP, or ALL (all protocols supported by the router). Status - The status of this entry either Enabled or Disabled. To add a new rule, enter the following data on the Port Triggering screen. Enter a port number used by the application when it generates an outgoing request. Select the protocol used for Trigger Port from the pull-down list, either TCP, UDP, or All. Enter the range of port numbers used by the remote system when it responds to the PC's request. Select the protocol used for Incoming Ports Range from the pull-down list, either TCP or UDP, or All. Click the Save button to save the new rule. - 25 - TL-R860 Cable/DSL Router User Guide Figure 4-20 Add or Modify a Triggering Entry There are many popular applications in the Popular Application list. You can select it, and the application will fill in the Trigger Port, incoming Ports Range boxes and select the Enable checkbox. It has the same effect as adding a new rule. To modify or delete an existing entry: 1. Click the Modify in the entry you want to modify. If you want to delete the entry, click the Delete. Click the Save button. Click the Enable All button to make all entries enabled Click the Disabled All button to make all entries disabled. Click the Delete All button to delete all entries Note: 1. When the trigger connection is released, the according opening ports will be closed. Each rule allowed to be used only by one host on LAN synchronously. [. . . ] On the "Remote Management" page, type a port number except 80, such as 88, into the "Web Management Port" field. Click "Save" and reboot the router. 2) Figure A-7 Note: Remote Management If the above configuration takes effect, to configure to the router by typing http://192. 168. 1. 1:88 (the router's LAN IP address: Web Management Port) in the address field of the web browser. 3) Login to the router, click the "Forwarding" menu on the left of your browser, and click the "Virtual Servers" submenu. On the "Virtual Server" page, enter "80" into the blank below the "Service Port", and your IP address below the IP Address, assuming 192. 168. 1. 188 for an example, remember to "Enable" and "Save". - 51 - TL-R860 Cable/DSL Router User Guide Figure A-8 Virtual Server - 52 - TL-R860 Cable/DSL Router User Guide Appendix B: Configuring the PCs In this section, we'll introduce how to install and configure the TCP/IP correctly in Windows XP. [. . . ]