User manual TP-LINK TL-WDN4800

[. . . ] Copyright © 2013 TP-LINK TECHNOLOGIES CO. , LTD. http://www. tp-link. com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Wireless statistics enables you to get detailed information about the current connected wireless stations. There are five submenus under the Wireless menu (shown in Figure 3-8): Wireless Settings, Wireless Security, Wireless MAC Filtering, Wireless Advanced and Wireless Statistics. Click any of them and you will be able to configure the corresponding function. The detailed explanations for each submenu are provided below. Figure 3-8 Wireless menu 3. 4. 1 Wireless Settings Selecting Wireless > Wireless Settings will enable you to configure the basic settings for your wireless network on the screen below (Figure 3-9). Figure 3-9 Wireless Settings SSID (Set Service Identifier) - Identifies your wireless network name. The same Name (SSID) must be assigned to all wireless devices in your network. The default SSID is TP-LINK_XXXXXX (XXXXXX indicates the last six unique characters of each device’s MAC address). For example, TEST is not the same as test. Region - Select your region from the pull-down list. This field specifies the region where the wireless function of the powerline extender can be used. It may be illegal to use the wireless 15 TL-WPA4220/TL-WDN4800 300Mbps AV500/AV200 WiFi Powerline Extender function of the powerline extender in a region other than one of those specified in this filed. If your country or region is not listed, please contact your local government agency for assistance. Wireless security can be configured on the following screen shown as Figure 3-10. Figure 3-10 Wireless Security Disable Security - Check this radio button to disable wireless security. If disabled, the wireless stations will be able to connect this device without encryption. It is strongly recommended that you choose one of the security types to enable security. WEP - Select 802. 11 WEP security. Figure 3-11 WEP • Type - You can select one of following types. Automatic - Select Shared Key or Open System authentication type automatically based on the wireless station's capability and request. Shared Key - Select 802. 11 Shared Key authentication type. Open System - Select 802. 11 Open System authentication type. 17 TL-WPA4220/TL-WDN4800 • 300Mbps AV500/AV200 WiFi Powerline Extender WEP Key Format - You can select ASCII or Hexadecimal format. ASCII format stands for any combination of keyboard characters in the specified length. Hexadecimal format stands for any combination of hexadecimal digits (0-9, a-f, A-F) in the specified length. WEP Key - Select which of the four keys will be used and enter the matching WEP key information for your network in the selected key radio button. These values must be identical on all wireless stations in your network. [. . . ] Press and hold the Pair button on powerline device C TL-PA4010 for one second. 37 TL-WPA4220/TL-WDN4800 Step 2. Step 3. 300Mbps AV500/AV200 WiFi Powerline Extender Within two minutes, press and hold the Pair button on Powerline device A/B for one second. Wait for about 60 seconds while your powerline devices are connecting. The Power LED on powerline device A/B and C will stop flashing and become solid light when the connection is made. Note: The sequence of Step 1 and Step 2 can be exchanged. [. . . ]