User manual TP-LINK TL-WN353G

[. . . ] TL-WN353G 54M Wireless PCI Adapter COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. Copyright © 2007 TP-LINK TECHNOLOGIES CO. , LTD. [. . . ] These encryptions are: Disabled, WEP, TKIP and AES. · 11 TL-WN353G Note: 54M Wireless PCI Adapter User Guide 1) Select different authentications and data encryptions, the security configuration is different. 2) When you select channel manually, the available network authentication are Open System, Shared key and WPA-None. 3) The RTWCU does not support WPA 802. 1x authentication in Windows Vista, while the Windows Zero Config Tools may satisfy your need. · · · · ASCII - Select this option, you can enter any ASCII characters to compose the password. PASSPHRASE - Select this option, you can enter the characters from 0~9 to compose the password. Key Index - Select the index of the password. Network Key & Confirm network key - The fields configure the network key. The two should be the same. 802. 1x configure - This configures the 802. 1x security, it is available when you select the data encryption as WPA 802. 1X, WPA2 802. 1X or WEP 802. 1X. · · · · · · 1. EAP TYPE - Select the EAP type for the 802. 1x configuration, the options are: GTC, TLS, LEAP, TTLS, PEAP. Tunnel - Select the tunnel: MD5, GTC, TLS, MSCHAP-V2. The option is necessary for the EAP type of TTLS and PEAP. Username - Enter the username for authentication. The option is necessary for the EAP type of TTLS and PEAP. Identity - Enter the identity for the authentication. Password - Enter the password for the authentication. The option is necessary for the EAP type of LEAP, TTLS and PEAP. Certificate - Select the certificate you apply. Open System authentication When you select the Open System as the authentication, the Disabled and WEP can be available for the data encryption. If you select Disabled, you don't need to configure any passwords. If you select WEP, you can configure the password as follows. For example: If the wireless network takes Open System authentication, WEP data encryption, the password is 64bit with the value of 0123456789. The index is 1. 12 TL-WN353G 54M Wireless PCI Adapter User Guide Figure 3-7 Step 1: Select the "Open System" as the Network Authentication. [. . . ] This bit pattern is called a chip (or chipping code). Even if one or more bits in the chip are damaged during transmission, statistical techniques embedded in the receiver can recover the original data without the need of retransmission. To an unintended receiver, DSSS appears as low power wideband noise and is rejected (ignored) by most narrowband receivers. another wireless LAN endpoint), the DSSS signal is recognized as the only valid signal, and interference is inherently rejected (ignored). [. . . ]