User manual TP-LINK TL-WPA4220KIT

[. . . ] TL-WPA4220 300Mbps AV500 WiFi Powerline Extender TL-WPA2220 300Mbps AV200 WiFi Powerline Extender REV1. 0. 0 1910010839 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO. , LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. [. . . ] It is not necessary to change the wireless channel unless you notice interference problems with another nearby access point. If you select Auto, then the powerline extender will choose the best channel automatically. Mode - Select the desired wireless mode. The options are: • • • • • 11b only - Only 802. 11b wireless stations can connect to the device. 11g only - Only 802. 11g wireless stations can connect to the device. 11n only - Only 802. 11n wireless stations can connect to the device. 11bg mixed - Both 802. 11b and 802. 11g wireless stations can connect to the device. 11bgn mixed - All 802. 11b, 802. 11g and 802. 11n wireless stations can connect to the device. If all of the wireless devices connected with the powerline extender can connect in the same transmission mode (e. g. 802. 11b), you can choose the Only mode (e. g. If you have some devices that use different transmission modes, choose the appropriate Mixed mode. Channel Width - Determines the channel width to be used. It is unnecessary to change the default value unless required. Enable Wireless Powerline Extender Radio - The wireless radio of the powerline extender can be enabled or disabled to allow or deny wireless stations to access. If it is enabled, the wireless stations will be able to access the powerline extender; otherwise, wireless stations will not be able to access the powerline extender. Enable SSID Broadcast - Selecting this check box will allow the device to broadcast its name (SSID) on the air. If it’s allowed, when wireless clients survey the local area for wireless networks to associate with, they will detect the SSID broadcast by the device. Note: To apply any settings you have altered on the page, please click the Save button, and then you will be reminded to reboot the device. 3. 4. 2 Wireless Security Selecting Wireless > Wireless Security will enable you to configure wireless security for your wireless network to protect your data from intruders. The powerline extender provides three security types: WEP, 16 TL-WPA4220/TL-WPA2220 300Mbps AV500/AV200 WiFi Powerline Extender WPA/WPA2 and WPA-PSK/WPA2-PSK. The default password can be found on the label at the bottom of the device. Wireless security can be configured on the following screen shown as Figure 3-10. Figure 3-10 Wireless Security Disable Security - Check this radio button to disable wireless security. If disabled, the wireless stations will be able to connect this device without encryption. [. . . ] Leave an existing Powerline Network: As the figure above shows, powerline device A, B and C have formed a powerline network. The user wants to remove one device (powerline adapter C) from this network. Press and hold the Pair button on powerline device C for at least 10 seconds. Powerline device C will reset and restart. [. . . ]