User manual TP-LINK TL-WR702N

[. . . ] 0 1910010547 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. Other brands and product names are trademarks or FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] Click any of them, and you will be able to configure the corresponding function. 1 Virtual Servers Choose menu “Forwarding → Virtual Servers”, and then you can view and add virtual servers in the screen as shown in Figure 5-27. Virtual servers can be used for setting up public services on your LAN, such as DNS, Email and FTP. A virtual server is defined as a service port, and all requests from the Internet to this service port will be redirected to the computer specified by the server IP. Any PC that was used for a virtual server must have a static or reserved IP Address because its IP Address may be changed when using the DHCP function. Figure 5-27 Virtual Servers Service Port - The numbers of External Ports. You can type a service port or a range of service ports (in XXX – YYY format, XXX is the start port number, YYY is the end port number). IP Address - The IP Address of the PC providing the service application. Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols supported by the Router). Status - The status of this entry, either Enabled or Disabled. Click the Add New… button, the next screen will pop-up as shown in Figure 5-28. Select the service port you want to use from the Common Service Port list. If the Common Service Port list does not have the service that you want to use, type the service port number or service port range in the Service Port box. Type the IP Address of the computer in the IP Address box. Select the protocol used for this application, either TCP, UDP, or All. Select the Enable to enable the virtual server. - 78 - TL-WR702N 150Mbps Wireless N Nano Router Figure 5-28 Add or Modify a Virtual Server Entry Note: If your computer or server has more than one type of available service, please select another service, and enter the same IP Address for that computer or server. Click the Modify in the entry you want to modify. If you want to delete the entry, click the Delete. Click the Enable/Disabled All button to make all entries enabled/disabled. click the Delete All button to delete all entries. Click the Next button to go to the next page and click the Previous button to return the previous page. [. . . ] 3 Type the Router’s LAN IP address (the default IP is 192. In the Preferred DNS Server field you can enter the same value as the Default gateway or type the local DNS server IP address. MIMO uses multiple transmitter and receiver antennas to allow for increased data throughput via spatial multiplexing and increased range by exploiting the spatial diversity, perhaps through coding schemes like Alamouti coding. The Enhanced Wireless Consortium (EWC) [3] was formed to help accelerate the IEEE 802. [. . . ]