User manual TRANSCEND TS0MFLRD6A

[. . . ] 7 How to Use the 6-in-1 Card Reader/Writer with Mac OS. . . . . . . . . . . . . . . . . . . . . 7 Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Warranty Introduction Thank you for purchasing Transcend's 6-in-1 Card Reader/Writer, a small device designed for fast easy data exchange using 6 types of storage media--CompactFlash, IBM MicrodriveTM, SmartMedia, Secure Digital, MultiMediaCardTM, and Memory Stick®. [. . . ] Please make sure the red LED light on the device is off before unplugging under Windows 2000. Driver Installation for Windows Me and Windows XP The Transcend 6-in-1 Card Reader/Writer is a driver-free device for Windows Me and Windows XP. You can connect it to an available USB port via the USB extension cable and don't have to install a special driver. Windows Me and Windows XP will detect the device and install all the associated files required for its use automatically. The process sequence is listed below: 4 Four Removable Disk drives with newly assigned drive letters will appear in My Computer. The 6-in-1 Card Reader/Writer is ready for use. Note: 1. Removal of 6-in-1 Card Reader/Writer in Windows 2000/Me/XP Please locate the green arrow icon as shown below. 2. Please right click on the icon. Left click to enter the removal window. 5 3. After the following window appears, please select the USB Mass Storage Device and click on Stop to continue. 4. The Stop a Hardware device window will appear. Please click on OK for removal. 5. When the Safe To Remove Hardware window appears, the 6-in-1 Card Reader/Writer is ready to be disconnected. 6 If you don't follow the above steps to remove the device, the Unsafe Removal of Device message (in Windows 2000) will appear: Driver Installation for Mac OS 8. 6 and Mac OS 9. X 1. Insert the Driver CD into the CD-ROM drive and drag folder McRW_b (under folder Mac on the Driver CD) to the desktop. Run Installer program under folder McRW_b on the desktop. Restart the computer to complete the installation process. Driver Installation for Mac OS X 10. 1. 2 The Transcend 6-in-1 Card Reader/Writer is a driver-free device for Mac OS X 10. 1. 2. You can connect it to an available USB port via the USB extension cable and don't have to install a special driver. Mac OS X 10. 1. 2 will detect the device and install all the associated files required for its use automatically. How to Use the 6-in-1 Card Reader/Writer with Mac OS 1. Connect the ends of the USB extension cable into the 6-in-1 Card Reader/Writer and an available USB port of your computer. Insert a storage card into the 6-in-1 Card Reader/Writer. You can then use the storage card as if it were a Mac HardDisk. 7 3. If you want to remove the storage card, you must first drag and drop the corresponding disk icon into the trashcan. After the disk icon disappears, you can remove the storage card. (Never remove a storage card directly because the system might halt. ) When there is in no storage card in the 6-in-1 Card Reader/Writer, you can disconnect the device from the USB port at any time. 4. Warning Never remove or insert a storage card or disconnect the USB extension cable while data are being transmitted. To avoid improper shutdown, open the transmitted file from its new location to ensure transmission has been completed. Specifications Transfer Rate·········································600 ~ 900K byte/sec Power supply ·········································DC 5V from USB port Slots for storage media··························CompactFlash Card Type I/II IBM Microdrive SmartMedia Card Secure Digital Card MultiMediaCard Memory Stick LED Indicators ·······································Red: Power on Green: Data traffic Operating Temperature ··························0°C ~ 70°C Storage Temperature ·····························-40°C ~ 70°C Humidity·················································0% ~ 90% RH Emission/Safety ·····································FCC Class B, CE, BSMI Dimensions············································125mm x 84mm x 21mm Weight ···················································105 g 8 USB Card Reader Limited Warranty "Above and beyond" is the standard we set ourselves for customer service at Transcend. [. . . ] Transcend USB Card Readers must be used with devices that conform to the recommended industry standards. Transcend will not be liable for damages resulting from a third party device that causes the Transcend product to fail. Transcend shall in no event be liable for any consequential, indirect, or incidental damages, lost profits, lost business investments, lost goodwill, or interference with business relationships as a result of lost data. [. . . ]