User manual TRANSCEND TS128MXDPC QUICK INSTRUCTION GUIDE

[. . . ] on the Driver CD to enable the WLAN Function. You must install the WLAN Utility found Before installing the WLAN Utility, verify that the switch is set to the "ON" position and carefully read the following steps. Install the WLAN Utility 1. Insert the Driver CD into the CD-ROM (Auto-Run supported). Select the WLAN Utility button. 2. Select Next. 3. Select Yes. 5 4. Select Next. You can select Browse to choose the folder destination. [. . . ] You can select the Site Survey tab in the IEEE 802. 11b WLAN Utility (USB) window to display all of the Access Points within communication range and double-click on one of them to connect. 12 Connect without an Access Point (Ad Hoc Mode) If you want to communicate with the other wireless devices directly (peer to peer) without using an Access Point, you must select Ad Hoc mode. Follow the procedures below to activate Ad Hoc Mode: 1. Select the Setting tab in the IEEE 802. 11b WLAN Utility (USB) window. Select 802. 11 Ad Hoc as the Network Type. 4. Select or type in the SSID, Country, and Channel. 13 Every member of the peer-to-peer network must select the same SSID and channel. Select Apply. 6. Select OK to activate 802. 11 Ad Hoc Mode. 14 Enable Encryption You can enhance the security of network by enabling the encryption. Select the Setting tab and then select Advance. From the WEP Required Mode drop-down menu box, choose either 64 bits (ASCII), 128 bits (ASCII), 64 bits, or 128 bits, then type in the WEP keys. You must type in the exact same WEP Key(s) that the network or access point uses. If Manual 64 bits (ASCII) is selected, enter the 5-digit WEP Key(s). If Manual 128 bits (ASCII) is selected, enter the 13-digit WEP Key(s). c. If Manual 64 bits is selected, enter the 10-digit WEP Key(s). d. Select OK to confirm the device removal. e. Select Yes to restart your computer and refer to the "Driver Installation for Windows 98SE" section to re-install the Win98 Driver. In Windows Me: a. Right-click the My Computer icon on the desktop and select Properties. 28 b. Select the Device Manager tab and double-click Network adapters. Select the WLAN miniUSB Adapter and right-click Properties. c. If an error message appears in the Device Status window, select Remove. 29 d. Select OK to confirm the device removal. e. Select Yes to restart your computer and re-insert your JetFlash. In Windows 2000: a. Right-click the My Computer icon on the desktop and select Properties. 30 b. Select Hardware tab and then select Device Manager. c. Right-click the WLAN miniUSB Adapter and then select Properties. 31 d. [. . . ] The decision by Transcend regarding eligibility of the product for repair or replacement will be final and binding. Transcend reserves the right to provide a functionally equivalent refurbished replacement product. Limitations: This warranty does not apply to products that fail due to accident, abuse, mishandling, improper installation, alteration, and acts of nature, improper usage, or problems with electrical power. Transcend JetFlash must be used with devices that conform to the recommended industry standards. [. . . ]