User manual TRANSCEND TS256MFLASHCP QUICK INSTRUCTION GUIDE

[. . . ] Besides, it is also a solid-state device that without moving parts to skip or break down. [. . . ] v1. 1 · Comply with SD Association File System Specification · Forward compatibility to MultiMediaCard Version 2. 11 · Supports Copy Protection for Recorded Media(CPRM) for music and other commercial media · Form Factor: 21. 5mm x 20mm x 1. 4mm Placement 9 1 2 3 10 11 4 5 6 7 8 Pin Definition 2GB Front Back Pin Name Type Description No. 1 CD/DAT3 I/O/PP3 Card Detect/Data Line [Bit3] 2 3 4 5 6 7 8 9 10 11 CMD VSS1 VDD CLK VSS2 DAT0 DAT1 DAT2 NC4 NC4 PP S S I S Command/Response Supply voltage ground Supply voltage Clock Supply voltage ground I/O/PP Data Line [Bit0] I/O/PP Data Line [Bit1] I/O/PP Data Line [Bit2] I/O/PP For Future Use I/O/PP For Future Use Transcend Information Inc. 1 TS128M~2GSDM Architecture miniSD Memory Card Transcend Information Inc. 2 TS128M~2GSDM Bus Operating Conditions · General Parameter Peak voltage on all lines All Inputs Input Leakage Current All Outputs Output Leakage Current -10 10 µA -10 10 µA miniSD Memory Card Symbol Min. -0. 3 Max. VDD+0. 3 Unit V Remark · Power Supply Voltage Parameter Supply voltage Supply voltage specified in OCR register Supply voltage differentials (VSS1, VSS2) Power up time -0. 3 0. 3 250 V ms From 0v to VDD Min. Symbol VDD Min. 2. 0 Max. 3. 6 Unit V Remark CMD0, 15, 55, ACMD41 commands Except CMD0, 15, 55, ACMD41 commands Note. The current consumption of any card during the power-up procedure must not exceed 10 mA. · Bus Signal Line Load The total capacitance CL the CLK line of the SD Memory Card bus is the sum of the bus master capacitance CHOST, the bus capacitance CBUS itself and the capacitance CCARD of each card connected to this line: CL = CHOST + CBUS + *CCARD Where N is the number of connected cards. MIL STD Method 1009 10. 000 mating cycles; test procedure: tbd. 10N 0. 15N. m or +/- 2. 5deg 1. 5m free fall UV: 254nm, 15Ws/cm² according to ISO 7816-1 No warppage; no mold skin; complete form; no cavities surface smoothness <= -0. 1 mm/cm² within contour; no cracks; no pollution (fat, oil dust, etc. ) Minimum 1000 Cycles (Slide force 0. 4N to 5N) Durability Bending Torque Drop test UV light exposure Visual inspection Shape and form WP Switch cycles Minimum moving force of WP witch 40gf (Ensures that the WP switch will not slide while it is inserted to the connector. ) Above technical information is based on industry standard data and tested to be reliable. However, Transcend makes no warranty, either expressed or implied, as to its accuracy and assumes no liability in connection with the use of this product. [. . . ] However, Transcend makes no warranty, either expressed or implied, as to its accuracy and assumes no liability in connection with the use of this product. [. . . ]