User manual TRANSCEND TS256MJFLASHM

[. . . ] USB 128MB­512MB JetFlashTM User's Manual Table of Contents Introduction Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Before Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In order to be able to play MP3 or WMA files, you must store them in the root directory of JetFlash. The recorded files (VXXX. WAV format) are saved on the folder "Voice", in an ascending order. With sufficient power: 128MB memory can store up to 9 hours of recorded voice. 256MB memory can store up to 18 hours of recorded voice. 512MB memory can store up to 36 hours of recorded voice. To achieve better quality recording, please keep voice source close to the microphone of JetFlash. If JetFlash is full and there is no memory available for voice recording, the Power/PLAY LED turns on. To make memory available for voice recording, delete some files or folders from JetFlash. To resume MP3 mode, press and hold PLAY/PAUSE LED turns off. button until the Record To Play the Recorded Files 1. Set HOLD switch to "OFF" position. Press and hold the PLAY/PAUSE button for a few seconds to power on (enter MP3 mode). Press and hold the REC button for a few seconds to enter Record mode. Press the PLAY/PAUSE button to play the recorded files. To resume MP3 mode, press and hold PLAY/PAUSE LED turns off. To power off, press and hold the PLAY/PAUSE LED turns off. button until the Record button until the Power/Play For more operating instructions, please refer to Basic Operation. 12 LED Indication Record LED (Red) off off off off off off off off on normal blink on on on on on Power/Play LED (Green) off fast blink on normal blink normal blink normal blink normal blink normal blink on off normal blink normal blink normal blink normal blink normal blink Repeat LED (Orange) off off off off on normal blink fast blink slow blink off off off on normal blink fast blink slow blink Power off Data transfer Power on (in MP3 mode) Play MP3 music Repeat a track Repeat all tracks The beginning of the portion you wish to repeat is marked in MP3 mode Repeat a portion of one track In Record mode Record voice Play the recorded file(s) Repeat a recorded file Repeat all recorded files The beginning of the portion you wish to repeat is marked in Record mode Repeat a portion of one recorded file Status Recover JetFlash If your JetFlash is ever damaged, you can use the Recovery program to restore its default settings. Running the Recovery program will erase all the data on the JetFlash. If there are bad blocks in the flash memory chip of JetFlash, the memory size of JetFlash after running the Recovery program will be smaller than the original memory size. To Recover JetFlash in Windows 98SE 1. Put the Driver CD into the CD-ROM (Auto-Run supported). button, then plug JetFlash into an available 13 Do not release the PLAY/PAUSE completed. 4. button until the Recovery procedures are Found New Hardware and New Hardware Found messages appear. [. . . ] A14: This problem occurs when you press the PLAY/PAUSE button while JetFlash is connected with a USB port. Please unplug JetFlash from the USB port then re-plug it. Q14: Q15: Why are the "Modified" times of voice files all the same? A15: Because of the limitations of the controller circuitry, JetFlash does not have a clock for use in recording file creation or save time. To better distinguish files from each other, you can rename them. Why can't the MP3 and voice recording functions work after I've formatted JetFlash using the "Quick Format" or "Full Format" option in Windows? [. . . ]