User manual TRANSCEND TS256MUSD QUICK INSTRUCTION GUIDE

[. . . ] Only Windows® 98 and Windows® 98SE need the enclosed driver. Write-Protect Function: Security Function: Write-protect switch provided Password protection provided · · · · Boot-Up Function: Makes JetFlash a bootable disk in USB-ZIP or USB-HDD boot mode LED: Indicates usage status of JetFlash 1 · System Requirements Desktop or laptop computers with USB port One of following operating systems: · · · · · · Windows 98/98SE Windows Me Windows 2000 Windows XP Mac OS 8. 6 or later Linux kernel 2. 4 or later Before Use 1. Please keep JetFlash away from heat, direct sunlight, and moisture. To prevent data loss and/or damage to JetFlash, never remove JetFlash from the USB port while data is transferring. [. . . ] Put the Driver CD into the CD-ROM (auto-run supported) and click the mFormat button. 9 mFormat Introduction Product Number, Drive Letter and Capacity Disk 1 information. Disk-Volume bar. Use it to make 2 partitions and adjust the capacity sizes. The minimum size is 2MB. Disk 2 information. Show Progress Status 10 Type of format Quick: Scan all blocks. If there are any bad blocks, mark them as Bad and perform a DOS Format of JetFlash. Full: Do a Surface Scan for a Write/Read Check. If there are any bad blocks, mark them as Bad and perform a DOS format of JetFlash. Configure device only: Partition JetFlash, and setup password protection and boot-up information. A USB Disk DOS format will be executed and all data stored on JetFlash will be lost. Configuration Slide the Disk-Volume bar to adjust the disk size of JetFlash. You can make one disk or two disks by adjusting the volume sizes. Click Start to continue. b. After the completion of format, you need to re-plug JetFlash to enable the setting. Restart your computer and press the Delete key (or whatever key combination is correct for your computer) during boot-up to enter Setup (CMOS Setup Utility) to reconfigure BIOS. Within the Advanced BIOS Features menu, change First Boot Device to USB-HDD. Now, your system can boot from JetFlash. During boot-up, JetFlash will be assigned drive letter C (C: \ > appears on the screen). If your 13 c. d. computer has a hard Drive, it will be assigned drive letter D. You can see boot-up files in Removable Disk. Please don't delete or move any of these files or boot up function will fail. Enable password protection cannot be set in this mode. Create Two Partitions Slide the Disk-Volume bar to adjust Disk 1 size to fit your need. The configure options will change to proper choices by different Disk 1 size. JetFlash enable to set as USB-ZIP or USB-HDD boot up mode as below. Option Disk 1 Size Disk 1 Configuration Make USB-ZIP startup disk Disk 2 Configuration BIOS 1 >2 MB Blank USB-ZIP 2 >2 MB Make USB-HDD startup disk Blank USB-HDD Windows 2000 cannot recognize the second partition. [. . . ] If your computer has a Floppy Drive, it will be assigned drive letter B. You can see boot up files in Removable Disk. Please don't delete or move any of these files or boot up function will fail. Option 2: Make USB-HDD startup disk (Only for Windows 98/98SE) a. [. . . ]