Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TRANSTEL GROUP RTS-DATAPAK-C(CS). We hope that this TRANSTEL GROUP RTS-DATAPAK-C(CS) user guide will be useful to you.
Lastmanuals help download the user guide TRANSTEL GROUP RTS-DATAPAK-C(CS).
Manual abstract: user guide TRANSTEL GROUP RTS-DATAPAK-C(CS)
Detailed instructions for use are in the User's Guide.
[. . . ] Operating Guide for RTS-DataPak-C and RTS-DataPak-C/S Circuit-Switched Data Transmission over CDMA Networks 1. Service must be activated by a cellular carrier. Record the assigned Dial Number and MIN. [. . . ] Green LED (DC PWR/MON) in steady bright/dim mode denotes standby/cellular idle. Rapid blinking, 2 sec on, 4 sec off, is ring alert, irregular rapid blinking: data transmission. If OT is displayed, press button SW2 for a few seconds to begin over-the-air activation (OTA). Adequate signal is indicated by numbers smaller than 90 (90 = 90 dBm). Depress SW2 a second time to display the MIN. If a serial unit is used (RTS-DataPak-C/S), depressing SW2 a 3 rd time displays the baud rate, typically 9, 600 baud. If a modem unit is used, depressing SW2 a third time will turn the display off. After a few minutes, the display is also automatically turned off. Use a PC or laptop (8 N 1 and 9, 600 baud) to connect to the DB9 setup port of the RTS-DataPak. Pressing ENTER returns the DATAPAK prompt. Typing HELP will show available commands. To begin over-the-air-activation, type OTA and press ENTER. After several messages indicate progress of programming, OTA PROGRAMMING SUCCESSFUL !Type STATUS to display programmed MIN, dial PHONE number, device baud rate (for serial units), RSSI, temperature, and battery voltage (if applicable). If MIN and PHONE numbers are different, type program to enter PHONE number. When programming is finished, disconnect from the serial setup port. [. . . ] To prevent sulfurization of the battery, the cellular transceiver is shut down when the battery voltage drops below 10. 7 volts. When a fresh battery is installed, press SW1 or apply AC power at the AC power input section to activate the RTS-DataPak. See Technical Support at www. transtelgroup. com.
I503282
Page 1 of 1 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE TRANSTEL GROUP RTS-DATAPAK-C(CS)
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TRANSTEL GROUP RTS-DATAPAK-C(CS) will begin.
.webp "Mode d'emploi TRANSTEL GROUP RTS-DATAPAK-C(CS)")
