User manual TRAYNOR AM100

[. . . ] The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. No naked flame sources, such as lighted candles, should be placed on the apparatus. The unit should be serviced only by qualified service personnel. [. . . ] the notch filter can be switched on or off. The clip LED can be used to gauge input level to avoid audible clipping. The sweepable notch filter control is located in the Channel 1 block and is used to eliminate feedback that is caused by the guitar being too close to the amp at higher power. When feedback does occur, make sure that the notch filter switch is pushed in, and then rotate the notch control slowly until the feedback is eliminated. Please note that if feedback noise occurs when you are in close proximity to the guitar amp, the notch filter may not help. Therefore either reduce power or move the guitar farther away from amplifier. Rotate the Low control to affect low frequency bass information, the MID control to affect mid frequencies, and the HIGH control to affect the higher frequencies. This channel accepts line level signals, a microphone (XLR), or any instrument with an active pickup with it's own volume control. Both channel inputs are balanced (TRS or Tip/Ring/Sleeve, +/-/gnd). The ¼-inch phone jacks also accept regular unbalanced cables. For best results and to reduce noise, it is advised that you use balanced (stereo) cables for interconnection wherever possible. * To connect a stereo source to the ¼-inch input of Channel 2's input, use an appropriate adapter, which terminates in a male ¼inch stereo plug (e. The signal is sent dry, with no equalization. cH2 EFX-Return This jack is located at the back of the unit. When a signal is fed back into the CH2 EFX-RTN jack it can go directly into the amps or it can be combined with the internal digital effects depending on whether the Channel 2 EFX switch is in or out. Do not use both the phone and XLR inputs at the same time, signals will be highly attenuated!No effects are sent through this output unless used prior to the amplifier (e. If you have your guitar plugged directly into an effect, then plugged into the AM100). [. . . ] The master control is used to increase or decrease the overall output of the AM100. It has no effect on the line out signal level or the Channel 2 effects loop. Connect a standard footswitch here to turn the internal effects system on or off. The Line Out is post Channel 1 and 2 but pre-effects, the gain controls and Channel 1's equalization do affect the output to the balanced line out, but the master volume Unlimited Warranty Yorkville's two and ten-year unlimited warranty on this product is transferable and does not require registration with Yorkville Sound or your dealer. [. . . ]