User manual TRAYNOR AM150

[. . . ] The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. No naked flame sources, such as lighted candles, should be placed on the apparatus. The unit should be serviced only by qualified service personnel. [. . . ] If it begins flashing you have turned up the GAIN, one or more of the EQ controls and/or the instrument to the point where the amplifier is running out of power headroom. Do not turn up further or distortion can occur. EFFECTS MASTER Control (dry/wet) and EFX FOOTSWITCH jack The control increases or decreases the intensity of internal effects (note, it does not regulate the intensity of any external effects which might be connected to channel 2). An optional footswitch plugged into the EFX FOOTSWITCH jack on the back panel may be used to activate or bypass the internal effects (only). From a **CD player, a tape deck or a mixer. Alternatively it can accept any guitar with active pickups (i. With a built-in preamp), or any keyboard instrument. it is balanced Tip (+) , Ring (-) , Sleeve , however it also accepts unbalanced cables. For best results and to reduce noise, it is advised that you use balanced cables wherever possible. the 3-pin XLR INPUT connector accepts any low-impedance dynamic microphone. Alternatively it can be used as a balanced line-level input, perhaps from a mixer's monitor or auxiliary output. **To connect a stereo source to the ¼-inch input of Channel 2's input, use an appropriate adapter, which terminates in a male ¼inch stereo plug (e. Do not use both the ¼-inch and XLR inputs on Channel 2 at the same time, signals will be highly attenuated! This control is used to increase or decrease the acoustic output of the AM150. It has no effect on the line out signal level or the Channel 2 effects send. There are 32 digital effects presets altogether divided into BANK A and BANK B with 16 presets in each. The banks are selectable via a pushbutton on the front panel of the amp near the POWER switch. when the button is in , BANK A is selected and the amber LED nearby illuminates. In the out position, Bank B is enabled and the light goes out. to select a specific effect , use the PRESETS control. A numeric selection of each preset and its description is located on the front panel of the AM150. Additionally an Effects Table with brief descriptions for the presets is located near the end of this Owner's Manual. [. . . ] If there is only a single, mono input on the mixer, use the LEFT/MONO jack. Autrement dit, les contrôles de gain de canal et les contrôles de tonalité du canal 1 affectent le signal de sortie, mais les contrôles effects master et master volume n'affectent pas le signal à cette sortie. 2 x 8 inch / 80 watts each 60 x 40 degree Mid Horn / addn'l Leson Tweeter 2 1/4 inch TRS Gain, low, Mid, High, Sweepable Notch Filter Notch Filter Defeat 1/4 inch TRS / XLR balanced connector Gain Internal Effects Defeat Yes Channel 1 = 100mV / Channel 2 = 1V XLR Pre DI out / 2 x 1/4 inch TRS Post Eq& Fx 1 Yes Yes / Rear Optional / Internal Effects bypass Power / Clip / Effects bank Optional tiltback leg (TB1) available 17 x 22 x 12 43 x 53 x 30 39. Unlimited Warranty Yorkville's two and ten-year unlimited warranty on this product is transferable and does not require registration with Yorkville Sound or your dealer. [. . . ]