User manual TRAYNOR AM50T

[. . . ] When using electric products, basic precautions should always be followed, including the following: Your unit should be connected to a power source only of the voltage specified in the owners manual or as marked on the unit. Do not use with an extension cord or receptacle unless the plug can be fully inserted. Precautions should be taken so that the grounding scheme on the unit is not defeated. [. . . ] The amplifier accepts the output from the active or passive pickups of your acoustic guitar, a microphone, or even Line-Level inputs. Other features include a spring reverb with level control, a balanced Line out and a Sweepable Notch Filter. The versatility and response of the AM50T will make it a pleasure to play for years to come. the Traynor AM50T has 2 input channels. Both channels can be use simultaneously. For example an acoustic guitar can be used on channel 1 while a microphone, a keyboard, or even another acoustic guitar (using an active pick-up) can be in use on channel 2. The green LED located under the Power switch will illuminate when the unit is turned on. It can accept either passive or active pick-ups (piezo/coil) Controls include Volume, Low and High equalization, as well as a sweepable Notch filter. The filter eliminates most feedback generated by guitar and/or amplifier, and also can be used to help shape the amplifier's response to the individual's taste. the Notch filter can be switched on or off. The clip LED can be used to gauge input level to avoid audible clipping. The sweepable Notch filter control is located in the Channel 1 block and is used to eliminate feedback that is caused by the guitar being too close to the amp at higher power. When feedback does occur make sure that the notch filter switch is pushed in, rotate the notch control slowly until the feedback is eliminated. Please note, if feedback noise occurs when you are in close proximity to the guitar amp, the notch filter may not help, therefore either reduce power or move the guitar further away from amplifier. The Channel 1 tone controls help you access the wide range of versatile sonic possibilities of the AM50T (these controls do not affect Channel 2). This channel accepts line level, balanced microphone (XLR), or any active pickup with it's own volume control. [. . . ] If this product should fail for any reason within two years of the original purchase date (ten years for the wooden enclosure), simply return it to your Yorkville dealer with original proof of purchase and it will be repaired free of charge. This includes all Yorkville products, except for the YSM Series studio monitors, Coliseum Mini Series and TX Series Loudspeakers. Freight charges, consequential damages, weather damage, damage as a result of improper installation, damages due to exposure to extreme humidity, accident or natural disaster are excluded under the terms of this warranty. [. . . ]