User manual TRAYNOR CUSTOM SPECIAL 50H

[. . . ] Use only with cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with the product. Follow the manufacturer's instructions when installing the product and use mounting accessories recommended by the manufacturer. The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. [. . . ] Effects Control 10 This controls the amount of return signal from the external effect plugged into the rear panel EfxRtnjack. Channel 2 can be used as the clean channel and the layout is similar to Channel 1, with independentGain, Volume, Treble, MiddleandBasstonecontrols. Channel 2 Tone Controls 15 The Treble, Middle and Bass tone controls help you shape your sound. This control is active only when Channel 2 is active. Effects Control 18 This controls the amount of return signal from the external effect plugged into the rear panel EFXRTNjack. The Resonance Control adjusts the damping factor of the speakers in the bass frequencies, helping loosen or tighten the bottom end. Turning the Resonance control up (clockwise) will add more rumble, turning it down (counter-clockwise) tightens up the bottom end. the voice switch bypasses the Resonance and Presence controls. The amplifier is now operating in an "open loop" mode which permits full tube tone without alteration. Master Volume 22 The Master volume controls the overall level of both channels. standby Switch and Indicator 23 This switch controls the high voltage power being supplied to the output tubes. This mode effectively keeps the tubes warmed up when the amp is not in use. The large, jewel indicator on the front panel glows Red when the amp is fully powered-up and changes to Yellow when the high voltage circuit has been turned off. During set breaks) shuts off the amplifier output stage and effectively increases tube life by reducing wear on the output tubes. Note: The preamp will remain active when in Standby mode allowing the use of the D. Output for direct recording without sound coming from the speakers. Amp Mode 25 The YCS amplifiers can be operated in two different modes, full-power class AB and lowpower class A. When operating in full-power mode, the full voltage is applied to the output and preamp tubes and the amplifier operates in a traditional class AB configuration. selecting the low-power mode cuts the operating voltage by half and increases the bias in the output tubes to full class A operation. This allows the output and preamp to operate with a great deal of more`saturation. This speaker output does not remain active when the amplifier is in standby mode so the YCS amplifier can be used as a preamp for recording. Note: The balanced XLR line output signal is affected by all the tone and volume controls, but not the Master volume or the Reverb. [. . . ] Select ATTENTION: Before speakers unit on, make sure EFX/Rvb / Boost are connected Footsw. / 2 12-inch 120 watts Input Channels: 1 Channel 1 - inputs: 1-1/4-inch shared with channel 2 Channel 1 - controls: Gain, Boost Level, Volume, Treble, Mid, Bass, Reverb, Effects Return Channel 1 - switches: Boost, Modern, Scoop Channel 2 - inputs: 1-1/4-inch shared with channel 1 Channel 2 - controls: Gain, Volume, Treble, Mid, Bass, Reverb, Effects Return Channel 2 - switches: Bright, USA/Brit, Expander Channel Switching: 2 Channels, Boost on Channel 1, Footswitchable Yes Presence, Resonance, Voice Master Outputs: Preamp Out (TRS), D. Out (XLR), Effects Send with Control (TRS) Line Out (type / configuration): Preamp Out (TRS), D. Out (XLR), Effects Send with Control (TRS) Line Out Sensitivity (Vrms): 300 mV Effects Volume: Master send, dual returns Effects Loop / Location: Rear Effects Footswitch / Function: Reverb and Effects Return Footswitchable Effects Return Sensitivity (Vrms): 300 mV Internal Reverb / Effects: Accutronics Dual Spring Long Tank LED Indicators: Ch1, Ch2, Boost, Power/Standby Protection: Mains Fuse External speaker output / location: 1 (rear panel) Other Features: Class A low power mode 15/15/25 Watts Dimensions (DWH, inches): 10. [. . . ]