User manual TRAYNOR XM100

[. . . ] When using electric products, basic precautions should always be followed, including the following: Your unit should be connected to a power source only of the voltage specified in the owners manual or as marked on the unit. Do not use with an extension cord or receptacle unless the plug can be fully inserted. Precautions should be taken so that the grounding scheme on the unit is not defeated. [. . . ] These RCA jacks are provided so that players can connect an external program music source (*tape or CD) to play along with for performance or practicing. Tip: Alternatively, a small mixer could be connected here turning the xm100 into a subcompact PA for low-volume rehearsals. Tip: We do not recommend that you use these jacks to connect and play two instruments at once. Set the VOLUME control to the level of sound desired. Tip: If distortion occurs, reduce the level of this and/or the BASS control. The three `overlapping' controls cover the instrument's entire audio bandwidth. Tip: If distortion occurs, reducing the Bass setting can often clean it up rather than a reduction of the Volume setting. It enables you to contour the overall depth (bottom end) and high-end presence of your sound. This balanced output provides a signal that you can send directly to the mixing console or additional power amplifiers using a balanced patch cable (a low-impedance mic cable will work). This pushbutton enables you to choose what type of signal you are sending out from the Line / D. Or Line, depending whether you want to have the xm100's tone controls shape your sound (Pre means no EQ, Post means with EQ). Tip: If you are running additional amplifiers onstage and want to employ the xm100 as a preamp, use the Post EQ setting. The Pre EQ setting is sometimes preferred if you are sending your signal to the mixing console. Note: With the button In the Pre EQ position, neither the volume nor the tone controls on the xm100 will affect the Line / DI Output signal. All such adjustments must be made at the mixer. Using shielded cables, connect the SEND jack to the input of the effects unit and its output to the RETURN jack. Tip: In-circuit, the loop is between the xm100's internal preamp and its power amplifier. If you are not connecting effects) double as an additional (post-EQ) line-level output and the Return jack as an isolating input to the power amp. [. . . ] If this product should fail for any reason within two years of the original purchase date (ten years for the wooden enclosure), simply return it to your Yorkville dealer with original proof of purchase and it will be repaired free of charge. This includes all Yorkville products, except for the YSM Series studio monitors, Coliseum Mini Series and TX Series Loudspeakers. Freight charges, consequential damages, weather damage, damage as a result of improper installation, damages due to exposure to extreme humidity, accident or natural disaster are excluded under the terms of this warranty. [. . . ]