User manual TRAYNOR XS800H

[. . . ] The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. Ensure that proper ventilation is provided around the appliance. No naked flame sources, such as lighted candles, should be placed on the apparatus. [. . . ] A green LED, located directly above the TUBEDrive switch, will illuminate. This control blends an underlying clean tone below the overdriven tone. In the Dry, counter-clockwise setting, clean signal is allowed to dominate the mix, with no overdrive. When rotated clockwise, into the Wet region, the overdriven sound becomes more apparent. The TUBEDrive overdrive will continue to increase until it is the dominant sound in the mix (fully Wet position). This helps you achieve a perfect Wet/Dry blend, between a completely clean and a completely saturated overdrive tone. The five overlapping controls cover the entire audio spectrum. each tone control permits a wide range of sonic adjustment. Each tone control has a variable boost and/or cut of 15 db. the center position denotes a neutral or nominal setting. Tip: It's a good idea, when starting out, to center all tone controls. While playing, adjust them until you achieve the desired sound. remember , if the Parametric Mid control is set at 0 , rotating the Frequency control will have no effect. The Bass control adjusts the level of the lowest note frequencies, Low-Mid the next range up from that. The Parametric Mid allows more precise control for the mid frequencies - more on this below). Tip: To use this control, set the position of the Parametric Mid level control to cut or boost. rotate the Frequency control until the desired frequency range is found. Once the frequency range is chosen, adjust the Parametric Mid level until the desired cut or boost level is achieved. tip: Using the Parametric Mid in conjunction with the Scoop feature. When using the Parametric Mid, it's possible to enhance the Scoop's capabilities by letting the two tone-shaping controls work in tandem. If you like the added bottom of the Scoop but wish to soften the midrange at 1Kz (but still maintain the higher frequencies); adjust the Parametric Mid Frequency control to 1. 0Kz and then use the Parametric Mid level control to cut as much as you need. [. . . ] This balanced jack is used to return effects processed audio signal back into the XS800H. the Effects Return control , located on the front panel , regulates the blend of effected and un-affected signal. This input can also be used as an auxiliary input for mixing in a secondary source of audio such as pre-recorded music. All speaker output jacks are in connected in parallel, minimum load impedance is 2-ohms (e. [. . . ]