User manual TRENDNET TE-16PNP

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. [. . . ] Use of NE-2000 Drivers: The TE-16PnP cards can use the same network drivers as the Novell NE-2000. Setup/Diagnostic program and LEDs: The TE-16PnP setup/diagnostic program tests all card functions to verify correct operation of the card. The LEDs on the card report network activity. Remote boot function: The cards can be used on PCs or diskless workstations for remote booting on the network. To use the remote boot function, a remote boot ROM (purchased separately) must be installed on the card. Runs a wide variety of networking software: The TE-16PnP cards can be used with all popular networking software. A complete list of supported software can be found at the end of this guide in the Specifications section. · · · · · Quick Installation Guide Congratulations on your purchase of a TE-16PnP adapter. With this adapter, you are sure to get the most for your investment -- as result of the rigorous quality-control programs implemented in all our products. Again, congratulations and happy networking!This guide applies to the following adapters: Model TE-16PnP Connector BNC, RJ-45 Media Thin coax, UTP Adapter Installation CAUTION: The adapter is packed in a plastic antistatic package to protect it during shipment. To avoid damaging any static-sensitive components, after removal from the package, be sure to reduce any static electricity on your body. You can touch the metal chassis of your computer, and maintain grounding by wearing a wrist strap attached to the chassis. Turn off your computer and then install the adapter into an empty 8 or 16 bit slot. On non-PnP systems, configure the card by running the card's setup program, TE16PNP. EXE. After installing and configuring the card (for both nonPnP and PnP systems), you can run the TE-16PnP setup program's diagnostic functions to test the reliability of the configuration. Install the appropriate network software driver. See Supported Network Drivers. Boot ROM Installation (Optional) A Boot ROM allows your computer to load the operating system over the network. Among the operating systems that can be loaded are Novell Netware, IBM LAN Server, and MS LAN Manager. [. . . ] They are arranged in a row and are located on the same side as the connectors(s). The following describes the function of each: Power/Tx Used State ON Link/Rx Used State ON Connector UTP/BNC Description There is power Connector UTP/BNC Description There is link between port & node Supported Network Drivers Before you could use an adapter in a certain networking environment, you need to install first its driver program for that type of environment. Otherwise, the adapter will not operate properly. [. . . ]