User manual TRENDNET TE100-MP1UN

[. . . ] Do not pinch, crimp or otherwise damage the power cord. If exposed to foot traffic, ensures that the cable is properly shielded and does not pose a tripping hazard. If using an extension cord, makes sure the total ampere rating of the products using the cord does not exceed the extension cord's ampere rating. Do not attempt to service this device, as opening or removing casing may expose you to dangerous voltage points or other risks. [. . . ] The Wired (LAN) interface should be used for initial configuration. Or click Skip if all the above steps have been done already. Select your Print Server, and then click Next to continue. If the Print Server does not show up, click the Refresh button. Click Next to configure the IP Address screen. Select Obtain IP Address automatically if you're LAN has a DHCP Server, otherwise select Use following IP address. For Use following IP address, enter an unused address from the range used on your LAN. Use the same Subnet Mask and Default Gateway as PCs on your LAN. 8. Follow the prompts to complete the installation. Page 9 11. Click Finish. If the desired Print Server is not listed: Check that both the Print Server and the printer are properly connected, and powered on. Check that the proper Printer Driver has been installed. Other PCs Setup If the Print Server is configured already, and you want other client PCs to use it, do the following procedure: 1. Insert the supplied CD-ROM into your drive. If the setup program does not start, run Autorun. exe in the root folder. 2. Click Install Utility, then click Install driver to install the bus driver & Utility. Page 10 3. Follow the prompts to complete the installation. The Print Server Utility will then run. Page 11 Print Server Utility Setup 1. The program will search for the Printer Servers on the network, and the Print Server Utility screen will be displayed. The names of the attached printer servers will be displayed if possible. If the printer is occupied by other user, the status field will display the information of the other user's name and IP address. Otherwise the default status icon should be if the printer is available. Page 12 If your Print Server is not listed: Check that both the Print Server and the printer are properly connected, and powered on. Check that the proper Printer Driver has been installed. 2. Once the Print Server has been connected successfully, the button will show "Disconnect" instead of "Connect". 3. Note: If Print Server has been idled for 5 minutes after connected, you will see the following message. The Print Server will be disconnected automatically if you don't respond to the message within 1minute. Page 13 Chapter 3 Management 3 Web-Based This chapter explains how to use your Web Browser to configure the Print Server. Overview The Print Server incorporates the HTTP server. [. . . ] TRENDNET NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION MAINTENANCE OR USE OF TRENDNET'S PRODUCTS. Page 19 TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY THIRD PERSON'S MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD. LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT TRENDNET'S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE. Governing Law: This Limited Warranty shall be governed by the laws of the state of California. Some TRENDnet products include software code written by third party developers. [. . . ]