User manual TRENDNET TE100-S16PLUS

[. . . ] TE100-S16plus 16-Port 10/100Mbps NWay Fast Ethernet Switch User's Guide FCC Warning This equipment has been tested and found to comply with the regulations for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user's guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. CE Mark Warning This is a Class A product. [. . . ] When installing, consider the following pointers: ?Install the Switch in a fairly cool and dry place. Technical Specification for the acceptable operating temperature and humidity ranges. Install the Switch in a site free from strong electromagnetic ?source, vibration, dust, and direct sunlight. Leave at least 10cm of space at the left and right hand side of ?Install the Switch on a sturdy, level surface that can support ?its weight, or on a 19" EIA standard-size equipment rack. For information on rack installation, please see the next section, Rack Mounting. When installing the Switch on a level surface, attach the ?rubber feet on the corners at the bottom of the Switch. The rubber feet cushion the Switch and protect the bottom of the Switch. 100Base-FX Module Installation The installation procedure for each module is the same. Additional information about each module is provided in the module's package. Locate the module slot at the switch's rear panel. Using a screwdriver, undo the two screws and remove the dust cover on the module slot. Note: reinstall the dusk cover when the slot is empty. Holding the module with the component-side up and connectorside going into the slot. Gently slide the module along the guides in the slot and firmly seat it in the internal connector. Using a screwdriver, replace the two screws and tighten them until snug. If the module is not present in the module bay, we recommend you install the dust cover over the module bay. For detail information on how to configure trunking, please refer to the Trunking Setting in the next section. QoS setting DIP switch: By using the QoS DIP switches, you can set the QoS function. [. . . ] The following are the possible LED indicator status for PC to Switch connection: 1. The "LINK/ACT" LED indicator lights green for 100Mbps connection or lights amber for 10Mbps connection. The "FDX/COL LED" indicator lights green if the LAN adapter is in full-duplex mode. The LED remains off when 22 the adapter is in half-duplex mode. Hub to Switch A hub (10 or 100BASE-TX) can be connected to the Switch via a two-pair Category 3, 4, 5 UTP/STP straight cables. [. . . ]