User manual TRENDNET TEG-S16G QUICK INSTALLATION GUIDE

[. . . ] Connect the Power Cord to the TEG-S16g/TEG-S24g and then to a power outlet. 2. Connect a CAT-5e or CAT-6 RJ-45 network cable from the computer to an available Ethernet port on the TEG-S16g/TEG-S24g. 3. Move the power switch to the on position. 2 3. LEDs Power Green: Power is on Not Illuminated: Power is off 10M/LINK/ACT Green (Solid): Link to another device Green (Blinking): Activity is occurring from the link Not Illuminated: Nothing is detected on the port 100M/1000M Green: Connection for the port is 2000Mbps (Full) Amber: Connection for the port is 100/200Mbps (Half/Full) Not Illuminated: Connection for the port is 10/20Mbps (Half/Full) or nothing is detected on the port 3 Technical Specifications Hardware TEG-S16g Standards TEG-S24g IEEE 802. 3 10Base-T; IEEE 802. 3u 100Base-TX IEEE 802. 3ab 1000Base-T; IEEE 802. 3x Flow Control Y Ethernet: Cat. [. . . ] The minimum length of the cable is 1. 5 meters and the maximum length of the cable is 100 meters. Verify that you have file sharing enabled. Please contact your Operating System support for more information. After I connect my PCs to the Switch, I can only get onto the Internet from one computer. The Switch was not designed to share Internet between multiple computers. You need to get an Internet router such as the TEW-652BRP. Where is the uplink port located on the Switch?Since all the ports on the Switch are Auto-MDIX, any of the ports can be used as an uplink port. If you still encounter problems or have any questions regarding the TEG-S16g/TEG-S24g please contact TRENDnet's Technical Support Department. 5 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TEG-S16g/TEG-S24g - 3 Years Limited Warranty AC/DC Power Adapter, Cooling Fan and Power Supply carry a 1 year limited warranty If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase. All products that are replaced become the property of TRENDnet. Replacement products may be new or reconditioned. TRENDnet does not issue refunds or credit. Please contact the point-of-purchase for their return policies. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product by any unauthorized service center. This warranty is voided if (i) the product has been modified or repaired by any unauthorized service center, (ii) the product was subject to accident, abuse, or improper use (iii) the product was subject to conditions more severe than those specified in the manual. Warranty service may be obtained by contacting TRENDnet within the applicable warranty period and providing a copy of the dated proof of the purchase. [. . . ] These codes are subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). Go to http://www. trendnet. com/gpl or http://www. trendnet. com Download section and look for the desired TRENDnet product to access to the GPL Code or LGPL Code. These codes are distributed WITHOUT WARRANTY and are subject to the copyrights of the developers. TRENDnet does not provide technical support for these codes. [. . . ]