User manual TRENDNET TEG-S2620IS

[. . . ] Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Radius Server IP: set the Radius Server IP address. Shared Key: set an encryption key for using during authentication sessions with the specified radius server. This key must match the encryption key used on the Radius Server. NAS, Identifier: set the identifier for the radius client. Server Port: set the UDP destination port for authentication requests to the specified Radius Server. Accounting Port: set the UDP destination port for accounting requests to the specified Radius Server. Select <Save>. 56 802. 1x System Configuration interface Per Port Configuration You can configure 802. 1x authentication state for each port. The State provides Disable, Accept, Reject and Authorize. Use "Space" key change the state value. 802. 1x Per Port Setting interface 57 Misc Configuration 1. Select <Edit> Quiet Period: set the period during which the port doesn't try to acquire a supplicant. TX Period: set the period the port wait for retransmit next EAPOL PDU during an authentication session. Supplicant Timeout: set the period of time the switch waits for a supplicant response to an EAP request. Server Timeout: set the period of time the switch waits for a server response to an authentication request. Reauthorize Maximum: set the number of authentication that must time-out before authentication fails and the authentication session ends. Reauthorize period: set the period of time after which clients connected must be re-authenticated. Select <Save> 802. 1x Misc Configuration interface 58 System Reset Configuration You can reset the system back to default value, reboot the system and update the system firmware. System Reset Configuration interface Factory Default Reset switch to default configuration. Press "Y", switch will load default setting. After finished load default setting, switch will reboot automatically. 59 Factory Default interface System Reboot Reboot the switch in software reset. TFTP Configuration It provides user to update firmware or restore EEPROM value or upload current EEPROM value. 60 TFTP Update Firmware interface Update Firmware It provides the TFTP updating firmware. Start the TFTP server, and copy new firmware version image file to the TFTP server. TFTP Server IP: type the IP of TFTP server. Firmware File Name: type the image file name. Press "ESC" to back to action line. [. . . ] In straight-through cable, pins 1, 2, 3, and 6, at one end of the cable, are connected straight through to pins 1, 2, 3 and 6 at the other end of the cable. The table below shows the 10BASE-T/ 100BASE-TX MDI and MDI-X port pin outs. Pin MDI-X 1 2 3 6 Signal Name Receive Data plus (RD+) Receive Data minus (RD-) Transmit Data plus (TD+) Transmit Data minus (TD-) MDI Signal Name Transmit Data plus (TD+) Transmit Data minus (TD-) Receive Data plus (RD+) Receive Data minus (RD-) 115 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TEG-S2620is 5 years If a product does not operate as warranted above during the applicable warranty period, TRENDnet shall, at its option and expense, repair the defective product or deliver to customer an equivalent product to replace the defective item. All products that are replaced will become the property of TRENDnet. [. . . ]