User manual TRENDNET TEG-S811FI

[. . . ] Notice This manual contents are based on the below table listing software kernel version, hardware version, and firmware version. If your switch functions have any different from the manual contents description, please contact the local sale dealer for more information. Firmware Version Kernel Version Hardware Version V1. 08 V1. 23 V1. 0R FCC Warning This Equipment has been tested and found to comply with the limits for a Class-A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Packet Collision: The counts of collision packet. Packet Dropped: The counts of dropped packet. Rx Bcast Packet: The counts of broadcast packet. Rx Mcast Packet: The counts of multicast packet. Click Clear button to clean all counts. 58 Port Statistics interface Port Control In Port control, you can view every port status that depended on user setting and the negotiation result. Port: select the port that you want to configure. The port can be set to disable or enable mode. If the port setting is disable then will not receive or transmit any packet. Negotiation: set auto negotiation status of port. Duplex: set full-duplex or half-duplex mode of the port. Flow Control: set flow control function is Symmetric or Asymmetric in Full Duplex mode. Security: When its state is "On", means this port accepts only one MAC address. Click Apply . 59 Port Control interface Port Trunk The Link Aggregation Control Protocol (LACP) provides a standardized means for exchanging information between Partner Systems on a link to allow their Link Aggregation Control instances to reach agreement on the identity of the Link Aggregation Group to which the link belongs, move the link to that Link Aggregation Group, and enable its transmission and reception functions in an orderly manner. Link aggregation lets you group up to seven consecutive ports into two dedicated connections. This feature can expand bandwidth to a device on the network. LACP operation requires full-duplex mode, more detail information refers to IEEE 802. 3ad. Aggregator setting 60 1. 2. System Priority: a value used to identify the active LACP. The switch with the lowest value has the highest priority and is selected as the active LACP. Group ID: There are three trunk groups to provide configure. Choose the "Group ID" and click Select . 3. LACP: If enable, the group is LACP static trunk group. If disable, the group is local static trunk group. All ports support LACP dynamic trunk group. [. . . ] For fiber connection, please notice that fiber cable mode and fiber module should be match. Faulty or loose cables Look for loose or obviously faulty connections. If they appear to be OK, make sure the connections are snug. If that does not correct the problem, try a different cable. Non-standard cables Non-standard and miss-wired cables may cause numerous network collisions and other network problem, and can seriously impair network performance. A category 5-cable tester is a recommended tool for every 100Base-T network installation. [. . . ]