User manual TRENDNET TEW-221PC

[. . . ] TEW-221PC 802. 11b Wireless CardBus PC Card User Manual REGULATORY STATEMENTS FCC Certification The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established certain rules governing the use of electronic equipment. Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interface, and 2) This device must accept any interface received, including interface that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] If the 802. 11b Wireless CardBus PC Card is found, it means that your device is properly installed and enabled. - 20 - Network Connection Once the driver has been installed, you must make some changes to your network settings. Configuring the Network Protocols for Windows 98/ME Go to Start ?Make sure that you have all the following components installed. 1. ?? 802. 11b Wireless CardBus PC Card IPX/SPX-compatible Protocol NetBEUI - 21 - ?? TCP/IP If any components are missing, click on the Add button to add them in. Microsoft provides all the protocols and clients required and listed above. After clicking Add, highlight the component you need, click Add. 6. Highlight Microsoft, and then double click on the item you want to add. For making your computer visible on the network, enable the File and Printer Sharing. Make up a name that is unique from the other computers' names on the network. Type the name of your workgroup, which should be the same name used by all of the other PCs on the network. 9. Make sure that "Shared-level access control" is selected. If connecting to a Netware server, share level can be set to "User-level access control. " - 23 - 10. When finished, reboot your computer to activate the new device. 11. Once the computer has restarted and Windows has booted up, a Logon window will appear and require you to enter a username and password. Make up a username and password and click OK. Do not click the Cancel button, or you won't be able to log onto the network. Double-click the Network Neighborhood icon on the windows desktop, and you should see the names of the other PCs on the network. - 24 - Configuring the Network Protocols for Windows 2000/XP 1. The SSID is the unique name shared among all points in your wireless network. The name must be identical for all devices and points attempting to connect to the same network. It shows the current SSID setting of the Wireless Network Adapter. (1, 2, 5. 5, 11Mbps or Auto) SSID Tx Rate - 30 - Item Channel Description It shows the selected channel that is currently used. [. . . ] In Wireless Network Connection Properties window, select the Wireless Networks tab. ?Use Windows to configure. . . Check the box to enable windows configuration. Note: Once you enable windows configuration, then the Network Status in the taskbar will disappear. You cannot use this utility to configure the wireless settings. - 44 - Note2: If you want to use the utility in Configuration Utility section to configure the wireless settings. [. . . ]