User manual TRENDNET TEW-648UBM

[. . . ] Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] System Requirements Before installation, check the following: Make sure your computer is running at least a 300MHz or above processor with 256MB RAM or above Make sure the USB ports are is USB 2. 0 port The operating system on your computer must be the following: XP (Service Pack 2), Windows Vista, Windows 7 802. 11n or 802. 11b/g access point or router. Make sure the environment has minimal interference and obstructions. If you are still experiencing low or no signal consider repositioning the wireless devices or installing additional access points. The use of higher gain antennas may also provide the necessary coverage depending on the environment. 9 SOFTWARE INSTALLATION This section describes how to install the driver and utility for the Micro Wireless N USB Adapter. Windows Based Utility Installation 1) Insert the Utility and Driver CDROM into your computer's CDROM drive and then click Install Utility. 2) Follow the InstallShield Wizard Instructions 10 3) Click Finish to restart the computer. 4) After the computer is rebooted, plug the Micro Wireless N USB Adapter into an available USB slot on your computer. 11 WIRELESS UTILITY SETTING The user can configure the wireless settings using the Wireless Adapter Configuration Utility. Doubleclick the utility icon that appears in the taskbar. The Wireless Adapter Configuration Utility is divided into six sections: Link Info, Configuration, Site Survey, Profile, WPS and About. Link Information This is the default screen after launching the Utility program. Status: Shows the associated BSSID (MAC address), which can be used to identify the wireless access point or router that you are connecting to. SSID: Shows the current SSID, which must be the same as your wireless access point or router in order to establish the connection correctly. Frequency: Shows the current frequency used for your wireless network. Wireless Mode: Shows the current wireless mode used. 12 Encryption: Shows the current encryption mode used. TxRate: Shows the current data rate used for transmitting. Channel: Shows the current channel for communication. Link Quality: Shows the link quality of the Micro Wireless N USB Adapter with the Access Point when operating under Infrastructure mode. Signal Strength: Shows the wireless signal strength of the connection between the Micro Wireless N USB Adapter with the Access Point. Data Rate: Shows the statistics of data transfer, and the calculation is based on the number of packets transmitted and received. [. . . ] Please contact the pointofpurchase for their return policies. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product by any unauthorized service center. [. . . ]