User manual TRENDNET TEW-649UB

[. . . ] Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Move the phone's base station as far away as possible from your wireless devices. If you are still experiencing low or no signal consider repositioning the wireless devices or installing additional access points. The use of higher gain antennas may also provide the necessary coverage depending on the environment. 8 SOFTWARE INSTALLATION This section describes how to install the driver and utility for the Wireless N USB Adapter. Windows Based Utility Installation 1) Insert the Utility and Driver CDROM into your computer's CDROM drive and then click Install Utility. 2) Follow the InstallShield Wizard Instructions 9 3) Click Finish. 4) Plug the Wireless N USB Adapter into an available USB slot on your computer. Driver Installation Windows Vista 1) Drivers will install automatically. Windows XP 1) The Found New Hardware Wizard appears Select No, not this time and then click Next. 10 2) Select Install this software automatically (recommended and then click Next. 11 3) Click Continue Anyway. 12 Windows 2000 1) Click Yes. 13 WIRELESS UTILITY SETTING The user can configure the wireless settings using the Wireless Adapter Configuration Utility. Doubleclick the utility icon that appears in the taskbar. The Wireless Adapter Configuration Utility is divided into six sections: Link Info, Configuration, Site Survey, Profile, WPS and About. Link Information This is the default screen after launching the Utility program. Status: Shows the associated BSSID (MAC address), which can be used to identify the wireless access point or router that you are connecting to. SSID: Shows the current SSID, which must be the same as your wireless access point or router in order to establish the connection correctly. Frequency: Shows the current frequency used for your wireless network. Wireless Mode: Shows the current wireless mode used. Encryption: Shows the current encryption mode used. TxRate: Shows the current data rate used for transmitting. [. . . ] Please contact the pointofpurchase for their return policies. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product by any unauthorized service center. [. . . ]