User manual TRENDNET TEW-657BRM

[. . . ] i Table of Contents INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Physical Details . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] You need to have a DHCP Server on your LAN to provide IP addresses to the Wireless clients using this Access Point. All traffic received on either the Wireless or LAN interface will be sent over the ADSL connection. Modem · · Notes: · · · Generally, you should NOT use modem mode. Only select this mode if you are sure this is what you want. After changing the mode, this device will restart, which will take a few seconds. The menu will also be changed, depending on the mode you are in. The Wireless Access Point can function in either Router or Modem mode. But generally it is not a good idea to combine a Modem with an Access Point, because all data received from the wireless stations will be sent over the modem connection. (Since the modem is transparent, it does not examine the traffic to determine whether the traffic is for the LAN or the WAN. ) For details on using Modem Mode, see Chapter 8. · 48 Operation and Status Operation - Router Mode Once both the Wireless ADSL Router and the PCs are configured, operation is automatic. However, there are some situations where additional Internet configuration may be required. Refer to Chapter 6 - Advanced Features for further details. Status Screen Use the Status link on the main menu to view this screen. Data - Status Screen ADSL Modem Status DownStream Connection Speed UpStream Connection Speed This indicates the status of the ADSL modem component. Displays the speed for the DownStream Connection. If connected, displays the speed for the Up Stream (upload) ADSL Connection. Internet Connection Method Connection Status Displays the current connection method, as set in the Setup Wizard. This indicates the current status of the Internet Connection · · Active - Connection exists Idle - No current connection, but no error has been detected. This condition normally arises when an idle connection is automatically terminated. Failed - The connection was terminated abnormally. This could be caused by Modem failure, or the loss of the connection to the ISP's server. · If there is an error, you can click the "Connection Details" button to find out more information. Internet IP Address This IP Address is allocated by the ISP (Internet Service Provider). If using a dynamic IP address, and no connection currently exists, this information is unavailable. It displays the MAC address for the WAN. Click this button to open a sub-window and view a detailed description of the current connection. Depending on the type of connection, a "log" may also be available. WAN MAC Address Connection Details LAN IP Address Network Mask DHCP Server MAC Address Wireless SSID 1 MAC Address SSID 2 MAC Address Region Channel Wireless AP Broadcast Name System Device Name The current name of the Router. This name is also the "hostname" for users with an "@Home" type connection. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. CE Approval CE Standards This product complies with the 99/5/EEC directives, including the following safety and EMC standards: · · · EN300328-2 EN301489-1/-17 EN60950 CE Marking Warning This is a Class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. 100 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TEW-657BRM ­ 3 Years Warranty AC/DC Power Adapter, Cooling Fan, and Power Supply carry 1 year warranty If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. [. . . ]