User manual TRENDNET TEW-PC16

[. . . ] TEW-PC16 11Mbps Wireless PCMCIA Network Card User's Guide Rev 1. 1 Regulatory Compliance FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in a ccordance with the instructions, may cause h armful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Ensure that the CD-ROM drive box is checked. 17 Wireless LAN card user's guide 6. Insert the driver CD-ROM into your CD-ROM drive and click Next. Windows 98 copies files to your hard disk drive, and you see the following screen: 18 --Driver installation for Windows and Linux 8. You should reboot your system to finish the installation. Note! Windows 98 may need to copy required system files and will prompt you to input the path to the files. Follow the instructions on your screen, and then click OK to continue. After you have rebooted the computer, system will start to install Wireless utility automatically. Please refer to procedures at Chapter 4. Driver installation for Windows 2000 Follow the steps below to install the Wireless LAN card drivers for Windows 2000. Insert the Wireless LAN card into an available PCMCIA slot on your notebook (refer to page 6 - Inserting the Wireless LAN card). After Windows 2000 detects the Wireless LAN card, the Found New Hardware Wizard window appears: 19 Wireless LAN card user's guide 3. Click Next to continue the installation. A screen appears prompting you to select an installation method: 4. Select Search for a suitable driver for my device (re commended) and click Next. The following screen appears: 20 --Driver installation for Windows and Linux 5. Click on CD-ROM drivers box and insert the driver disc into CD-ROM drive. The following screen appears: 21 Wireless LAN card user's guide 7. Click Finish to complete the installation. Then system will start to install Wireless utility automatically. Please refer to procedures at Chapter 4. 22 --Driver installation for Windows and Linux 23 Wireless LAN card user's guide Driver installation for Windows NT 4. 0 This installation procedure assumes that you have installed the network components (i. e. Network Clients and Protocols) in your NT4. 0. To check whether the network components have been installed, double click the Network icon in the Control Panel. If it has not been installed, refer to the Windows NT 4. 0 installation guide for instructions on installing the component. Follow the steps below to install the driver. Insert the Wireless LAN card into an available PCMCIA slot on your Notebook (refer to page 6 - Inserting the Wireless LAN card). [. . . ] Install the card drivers on both notebook computers (refer to Chapter 3). Install the software on both notebook computers (refer to page 34). After you have installed the software and rebooted, double click the icon in the lower corner of your screen to open the configuration utility: 42 --Using the Wireless Utility 5. Select AdHoc from the Mode dropdown list. [. . . ]