User manual TRENDNET TFC-110

[. . . ] TFC-110 Series 10/100BASE-TX to 100BASE-FX Fast Ethernet Media Converter Quick Installation Guide FCC Class B Certification This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Back-pressure & IEEE802. 3x compliant flow control ??Used as a stand-alone device or with a chassis ??Hot-swappable when used with a chassis 4 Installation This chapter gives step-by-step installation instructions for the Converter. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements: 1. The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius). The relative humidity should be less than 90 percent, non-condensing. Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength. Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes on either side of the switch or the fan exhaust port on the side or rear of the equipment. The power outlet should be within 1. 8 meters of the switch. 5 Connecting to Power 1. This Converter is a plug-and-play device. Connect the supplied AC to DC power adaptor with a power voltage of 7. 5VDC/1. 5Amp to the receptacle on the rear panel of the converter, and then attach the plug into a standard AC outlet with a voltage range from 100 to 260VAC. Sliding Switch There is a sliding switch for duplex mode setting for fiber port. [. . . ] 5, up to 100 m (328 ft) 100BASE-FX -62. 5/125um or 50 /125um multi- mode fiber optic ca ble, up to 2 km (412 meters in half-duplex mode) 9/125um or 10/125um single-mode fiber optic cable, up to 75 km (412 meters in half-duplex mode) Dimensions Weight Power Power Consumption L120 × W88 × H25 mm 305 g External power adaptor 7. 5V 1. 5A 7. 2W Max. 9 Operating Temperature Storage Temperature Humidity Emissions 0°C ~ 40°C (32°F ~ 104°F) (-13°F ~ 158°F) -25°C ~ 70°C 10 ~ 90%, non-condensing FCC part 15 Class B, CISPR ClassB, VCCI Class B, CE Mark Ordering Information Please include the following information when ordering: Fiber type: multi-mode or single-mode Fiber connector type: SC, LC or MT-RJ Segment distance range for the fiber port TX port Connector Type RJ-45 Cabling Copper Wire FX port Connector Type SC MT-RJ LC SC SC SC Cabling Multi-Mode Fiber Multi-Mode Fiber Multi-Mode Fiber Single-Mode Fiber Single-Mode Fiber Single-Mode Fiber Segment Distance Max. 100 m P/N:6012-MC11000 Rev:A1-01 10 [. . . ]