User manual TRENDNET TIM-128

[. . . ] ISDN TA PC Card User Manual INTRODUCTION The ISDN TA PC Card brings the latest in mobile communication technology with flexibility and convenience. With the wide range ISDN signaling protocols switches supports, mobile experts may enjoy the mobile communication across the world and the high speed digital service. System Requirements Pentium 75 or above At least 30MB free hard disk space At least 16MB RAM PCMCIA Type II/III slot PCMCIA Card Services and Socket Services v. 2. 1 or higher pre-installed Windows 95/98/2000 or Windows NT pre-installed Specifications Standard PCMCIA 2. 1 & JEIDA 4. 1 compliant ISDN standards Basic Rate Access (2B+D) S/T-Interface: Compliant with ITU-T I. 430 D-channel: ITU-T Q. 921, Q. 931 ETSI NET3 B-channel: V. 120, V. 110, X. 75/T. 70NL/ISO8208 Async-to-Sync PPP conversion Multilink PPP, 56 K Modem (CAPI only) G3 fax (CAPI only) -1- Voice (CAPI only) Line Rate 64/56 Kbps on 1 B-channel 128/112 Kbps on 2 B-channel (PPP/MP) 64/56Kbps on 1 B-channel 16Kbps on D-channel ISDN Network & Switch Compatibility National ISDN-1 (NI-1) AT&T 5ESS Custom Northen Telecom DMS-100 Custom DSS1 (Euro-ISDN) INS-Net 64 Application Program Interface Supported VCOMM WinISDN CAPI 2. 0 NDIS WAN Operating System Supported Windows 95 and OSR2 Windows 98 Windows 2000 Windows NT 4. 0 Physical Specifications RJ-45 ISDN line interface Dimension: 85. 6 x 54 x 5 (mm) PCMCIA Type II -2- Parts Names 15-pin PC Card Connector ISDN Network Connection Cable -3- HARDWARE INSTALLATION If you are using the ISDN TA PC Card under Windows 95/98/2000, Do NOT insert the PCMCIA card until after the software installation is completed. 1. 2. Align the PC card with the arrow sign pointing toward the computer's PCMCIA slot. Connect the 15-pin PC card connectors with the two exposed end of the PC card. [. . . ] Click the Answerphone function bar to toggle to the ON state. (for the OFF state is for ISDN Phone utility. ) - 31 - 2. Click Settings to record/edit your greeting message. The incoming voice message will be stored in "Inbox". Double-click the received voice mails to play back the messages. ISDN Phone 1. 3. Start RVS-COM "CommCenter". Clear the selections of the Accept calls and the Answerphone check box. Open the ISDN tab, select the appropriate ISDN voice coding scheme for your location. A-law is generally used in European countries, and Mu-law for North America. - 32 - 4. 9. Make sure all the other settings in "CommCenter" are correctly configured. Run "Config" in "Configuration Utility". Choose appropriate "Voice Encoding" scheme. The setting should be consistent with RVS-COM in step (3). Start Telephone in "RVS-COM Lite" program group. Click "Answerphone" function bar to the OFF state (for the ON state is for "Answering machine" services). Connect the microphone and speakerphone to the audio interface(s) on your laptop. When the calls come in, the "RVS Phone" will appear automatically. Click Accept button to pick up the calls. When finished, click "Hang Up" to end the connections. NDIS Mode Installing the NDIS driver NDIS is dedicatedly designed for Internet connections with Microsoft ISDN Accelerator Pack. For Windows 95/98 environment, perform the following steps to install the NDIS driver. While for Windows 2000, NDIS driver will be automatically installed when the device driver is installed onto your system, your may just skip the following procedures. Make sure ISDN Accelerator Pack is pre-installed, and the PC Card is firmly seated. Select "No" for "Do you want Windows to search for your new hardware". Select "Network adapters" in "Hardware types" list. [. . . ] Type AT&F&Wn<Enter> if you get lost in the AT command and want to go back to the factory default settings. Exception: Do not proceed the following commands with an AT prefix or end it by pressing Enter. +++ Escape sequence The escape sequence allows the modem to exit data mode and enter on-line command mode. While in on-line command mode, you may communicate directly to your modem using AT commands. [. . . ]