User manual TRENDNET TK-200

[. . . ] Before installation, please make sure all peripherals and computers are powered off. Connect one keyboard, monitor and mouse to KVM switch's console port. [. . . ] Support Video Quality Up to 1920X1440, Band width: 200MHz. No software Required; user can select PC via Push button or Hot-keys. Auto Scan mode for monitoring PCs (4 sec. interval) Keyboard status restored when switching between PCs. Buzzer sound confirming port switching action. In Hot key Mode, use "Up-Arrow" to Selected the previous port, "Down Arrow" to select the next port and Press "S" key to set the KVM switch into Auto Scan Mode. Note: If no command is entered in two seconds after entering the Hot Key Mode, the switch will cancel the Hot Key operation. VGA K1 M1 Model No: TK-200 VGA 4 K/B 4 A VG A MOUSE 4 K1 VGA 2 M1 K/B 2 K/B MOUSE POWER MOUSE 2 Previous Channel Next Channel S Auto Scan SYSTEM REQUIREMENTS SPECIFICATION Model no. Console Side Computer Side TK-200 One VGA Monitor One PS/2 keyboard One PS/2 Mouse Two HDB 15pin male to maleVGA cables. Two PS/2 cables male to male for Keyboard. Two PS/2 cables male to Male for Mouse. TK-400 One VGA Monitor One PS/2 keyboard One PS/2 Mouse Four HDB 15 pin male to male VGA cables. Four PS/2 cables male to male for Keyboard. Four PS/2 cables male to male for Mouse. TROUBLESHOOTING Note: Please ensure all cables are correctly seated in the connection ports. Properly label the cables to avoid confusion. 1. TK-200/TK-400 KVM switch draws power from computer's keyboard port. [. . . ] 5. Avoiding moving the mouse or pressing the mouse button when switching from port to port. PACKAGE CONTENTS TK-200 TK-400 2-port KVM switch * 1 + User's Guide * 1 + KVM cables * 2. 4-port KVM switch * 1 + User's Guide * 1. -MAY-09-2001- [. . . ]