Detailed instructions for use are in the User's Guide.
[. . . ] Turn off both computers and their peripherals, and disconnect all power cords.
2. Connect the shared keyboard, monitor, mouse, microphone (optional) and speaker (optional) to the KVM Switch's console . Use the provided KVM and audio cables to connect your PC to your KVM switch.
KVM Cable
Audio Cable
TK-208 PC
TK-408
4. Turn ON the first computer and wait until startup completes.
PC 1
2
English
5. [. . . ] Turn ON the second computer and wait until startup completes.
PC 2 (TK-208) PC2, PC 3, PC4 (TK-408)
Your installation is now complete.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to register your product Online at: www. TRENDnet. com/register Thank you for choosing TRENDnet
3
English
3. Operation
Note: For PC switching, you can use the face-panel buttons of the KVM Switch, or a Hot-Key command sequence via keyboard.
Face-Panel Buttons
Press the corresponding face-panel button to select your PC.
Hot-Key Command Sequence
After pressing the ScrLk key, you have 2 seconds to press the ScrLk key again. If you do not press the key within 2 seconds, the switch will exit Hot-Key mode. Hot-Key command works on the top row numbers keys only. When the binding of PC & Audio/Microphone port switching is enabled by the Hot-Key sequence, any PC and Audio/Microphone source can be bound together. For non-PnP OS(Linux, Windows NT 4. 0), please use the following commands to reset the mouse setting:
2-key mouse setting:
ScrLk
+ ScrLk +
ScrLk ScrLk
M
+
M M
1
3-key wheel mouse setting: 5-key wheel mouse setting:
+ ScrLk + + ScrLk +
+ +
2 3
4
English
Quick Reference Sheet for TK-208/TK-408
Command
Select PC
Hot-Keys
ScrLk
Description
X
Select the active PC channel.
+ ScrLk + + ScrLk +
x = 1 ~ 2 for PC channel number
Select Audio/Mic Channel
ScrLk
FX
Select the active Audio/Mic channel
(Fx is a function key) FX = F1~F4
Bind PC & Audio/Mic Source
ScrLk
+ ScrLk +
Q
Enable the binding of selected PC and Audio/Microphone source
UnBind PC & Audio/ Mic Switching
ScrLk
+ ScrLk + + ScrLk +
W
Disable the binding of PC port and Audio/Mic port switching.
Next higher PC channel Next lower PC channel Console Mouse/ Keyboard Reset
ScrLk
Select the next higher available computer
(Arrow up)
ScrLk
+ ScrLk +
(Arrow down)
Select the next lower available computer
ScrLk
+ ScrLk + + ScrLk +
End
Reset mouse/keyboard on the console side. (works on non-PnP OS only) Autoscan through every connected channel for quick screen browsing of each channel (scan delay = 10 seconds). Terminate Autoscan activity.
Autoscan
ScrLk
S
Stop Autoscan
Press any key on keyboard
Hot-Key Convention: The Hot-Key notation ScrLk + ScrLk + (key) denotes that you should hit the individual key consecutively one at a time, not simultaneously.
5
English
Troubleshooting
Q1: Where is the power supply?A1: The TK-208/TK-408 does not require a power supply. It draws power from your computer's keyboard connection. This warranty is voided if (i) the product has been modified or repaired by any unauthorized service center, (ii) the product was subject to accident, abuse, or improper use (iii) the product was subject to conditions more severe than those specified in the manual. Warranty service may be obtained by contacting TRENDnet office within the applicable warranty period for a Return Material Authorization (RMA) number, accompanied by a copy of the dated proof of the purchase. Products returned to TRENDnet must be pre-authorized by TRENDnet with RMA number marked on the outside of the package, and sent prepaid, insured and packaged appropriately for safe shipment.
7
WARRANTIES EXCLUSIVE: IF THE TRENDnet PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDnet'S OPTION, REPAIR OR REPLACEMENT. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TRENDnet NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION MAINTENANCE OR USE OF TRENDnet'S PRODUCTS. TRENDnet SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY THIRD PERSON'S MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD. LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDnet ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT TRENDnet'S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE. Governing Law: This Limited Warranty shall be governed by the laws of the state of California. AC/DC Power Adapter, Cooling Fan, Cables and Power Supply carry a 1 Year Warranty
8
Certifications This equipment has been tested and found to comply with FCC and CE Rules. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.
Waste electrical and electronic products must not be disposed of with household waste. Check with you Local Authority or Retailer for recycling advice.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. [. . . ]