User manual TRENDNET TPL-310AP

[. . . ] Safety Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Fill in the MAC address that you wish to control, and give a definition to it. (MAC Address Format: xxxxxxxxxxxx) Lists the MAC Access Control Settings you have added before. Click on the list to change configuration. To Delete the station on the list, mark the check box in the select item and click the "Delete Selected". If you want to delete all Wireless Access Control Mode MAC Address & Comment Current Access Control list stations on the list, click "Delete All" to remove all of them. * Please click on the Apply Changes button or the Reset button to save/reset the configuration. 3. 4. 8 WDS Settings Wireless Distribution System (WDS) mode uses wireless media to connect to other wireless access points. Another term for this feature is wireless point to point or point to multi-point bridging. Wireless access points using WDS mode must be configured to use the same channel number, wireless security type, and wireless security key. Add other WDS enabled wireless access points using their device MAC addresses. This feature is only available when using WDS, AP+WDS, Mesh, or AP+Mesh modes located under Wireless > Basic Settings. To use WDS, you will require at least 2 or more wireless access points that support WDS. Note: WDS is not a wireless standard and connectivity may or may not be established between different wireless access point devices that support this feature. It is recommended to use the same device model when using this feature. Items MAC Address & Comment Information Fill in the MAC address that you wish to control, and give a definition to it. (MAC Address Format: xxxxxxxxxxxx) Data Rate The transmit limitation of data packets of this wireless AP. The wireless AP will use the highest possible selected transmission rate to transmit the data packets. Lists the WDS Settings you have added before. Click on the list to change configuration. To Delete the station on the list, mark the check box in the select item and click the "Delete Selected". If you want to delete all stations on the list, click "Delete All" to remove all of them. Current WDS AP List * Please click on the Apply Changes button or the Reset button to save/reset the configuration. 1. Click on Wireless and then click Basic Settings. For Mode, select AP+WDS, WDS, Mesh, or AP+Mesh. Click on Wireless and the click WDS Settings. [. . . ] ***Maximum wireless signal rates are referenced from IEEE 802. 11 theoretical specifications. Actual data throughput and coverage will vary depending on interference, network traffic, building materials and other conditions. **** Networked Powerline devices need to be plugged into power outlets that are on the same electrical system. *****It is not recommended to use this product on electrical systems that use AFCI circuit breakers or plugged into GFI protected outlets as this may cause performance degradation or loss in connectivity. Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TPL-310AP ­ 3 Years Warranty AC/DC Power Adapter, Cooling Fan, and Power Supply carry 1 year warranty. If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. [. . . ]