User manual TRENDNET TU2-ETG

[. . . ] 5 Windows 7/Vista . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Windows XP/2000 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Mac Driver Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Mac OS X 10. 5. 2 ~ 10. 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It eliminates the need to use crossover cables. Upon your connection, a message pops up in the notification area indicating your connection speed. The adapter's AutoSense feature can automatically detect the network's maximum line speed. To have a 1000Mbps connection, your network device (e. g. , switch, router or DSL modem) must also support 1000Mbps. Configuring Network Settings You should configure your Ethernet adapter as required according to your network environment. If you are unsure about the settings, consult your network administrator for assistance. The following describes how to launch the network settings window for your Ethernet adapter. Windows 7/Vista After the installation, a local area connection icon is automatically created for your Ethernet adapter in the Network Connections folder. You can access Network Connections folder by selecting Start > Control Panel > Network and Internet > View Network status and tasks > Management Network Connection or Changing Adapter Setting. Windows XP/2000 After the installation, a local area connection icon is automatically created for your Ethernet adapter in the Network Connections folder. You can access Network Connections folder by selecting Start > Settings > Control Panel > Network and Internet Connections. 5 In the Network Connections folder, double-click the connection icon for your adapter. Then the Local Area Connection Properties window appears. Mac Driver Installation Mac OS X 10. 5. 2 ~ 10. 6 1. Please connect the Ethernet adapter to a free USB port. The system will pop up a message "A new network interface has been detected" 2. If the message is not pop up , please start System Preferences and select Network, then click the "" to add an "USB Gigabit Ethernet " service. Click "Network Preferences. . . " to setup, 3. Select "USB Gigabit Ethernet " then click "Advanced" to setup the network by either using static IP or DHCP. 7 3. If select "Using DHCP" Mode, please click"Renew DHCP License" to get the IP address , Otherwise, please enter the IP information that provided by your Network Service Provider. 4. A new Ethernet network connection is established. 5. To verify the installation, please click open GO > Utilities > System Profile > Hardware > USB > to see if the Ethernet adapter is properly installed. 9 3. Specifications Hardware Standards USB 2. 0, 1. 1 IEEE 802. 3: 10Base-T IEEE 802. 3u: 100Base-TX IEEE 802. 3ab: 1000Base-T Ethernet: 10Mbps/20Mbps (Half/Full Duplex) Fast Ethernet: 100Mbps/200Mbps (Half/Full Duplex) Gigabit: 2000Mbps (Full Duplex) 20KB SRAM 20KB SRAM Windows 7(32/64-bit) / Vista 32/64-bit) / XP (32/64-bit), 2000 Mac 10. 5. 2~10. 6 Power, Link Bus-Powered Suspend Mode Hibernate Mode Operating: 0 C~ 40 C (32 F~ 104 F) Storage: -10 C~ 55 C (14 F~ 131 F) Max. 85% (Non-Condensing) CE, FCC Data Transfer Rate Embedded Buffers Supported OS LEDs Power Power Management Temperature Humidity Certifications Power Consumption 950mW Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TU2ETG ­ 3 Years Limited Warranty AC/DC Power Adapter, Cooling Fan, and Power Supply carry 1 year warranty. If a product does not operate as warranted during the applicable warranty period, TRENDnet shall reserve the right, at its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty continues from the original date of purchase. All products that are replaced become the property of TRENDnet. Replacement products may be new or reconditioned. [. . . ] LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT TRENDNET'S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE. Governing Law: This Limited Warranty shall be governed by the laws of the state of California. Some TRENDnet products include software code written by third party developers. [. . . ]