User manual TRENDNET TVP-SP2

[. . . ] TVP-SP2 User's Guide Safety Instructions Always read the safety instructions carefully Keep this User's Manual for future reference Keep this equipment away from humidity If any of the following situation arise, get the equipment checked by a service technician: · · · · The equipment has been exposed to moisture. The equipment has been dropped and damaged. The equipment has obvious signs of damage. The equipment has not been working well or you cannot get it working according to User's Manual. Copyright Statement No part of this publication may be reproduced in any form by any means without prior written permission. [. . . ] Press the Contact List key to load the Skype contact list. Only one contact is displayed at a time. The top-right icon indicates the online status of the contact. means online while means offline. Note: Letter with diacritical marks, such as German umlaut letters (Ä, ä, Ö, ö, Ü, ü), is not displayable and will be replaced by a blank instead on the display. Scroll with Scroll Up / Down to reach the desired contact. You can keep pressing Scroll Up / Down to quickly scroll through the list. (To exit the contact list, press the Contact List key again or press the key. To call current contact, just press the communication, the screen is as below. 4. When the call is answered, appears on the screen. To end the call, press 18 Using the Contact List on Skype Window 1. Press the Skype On key to open the Skype window (if not open) and switch to the Contacts tab. You can use mouse or the Scroll Up / Down key on the USB Speakerphone to scroll through the contact list. Press the key to call the desired contact. To end the call, press . Speed Dialing 1. In Skype window, go to the Contacts tab and select your desired contact. Right-click the contact and select Set Speed-Dial. 2. Assign a number as a speed dial number using your keyboard. 3. Press the speed dial number using the USB Speakerphone. Note: In case you want to clear the number you entered, press the 4. key. 19 TVP-SP2 User's Guide Using SkypeOut to Call Regular Phones SkypeOut allows you to place calls to regular telephones or mobile phones. This feature allows you to call from Skype to friends who are not using computers but still use regular phones. To use SkypeOut, you should buy SkypeOut credits first. [. . . ] For the information on compatible operating system and system requirements, please visit the Skype website. 32 7. Specification Solution 8 bits DSP Voice Processing Echo-cancellation: up to 45 dB Audio Output Frequency Range: 44. 1K Hz Audio Input Sampling Rate: 8K Hz, 8 bits Interface Connectors USB 1. 1 compliant USB B type female connector 3. 5mm stereo jack for earphone 3. 5mm jack for microphone 5V DC IN jack Speaker Size: 41 x 71 mm Response Frequency: 100 Hz~20K Hz Output Impedance: 1W / 8 Ohm Volume: 100dB Microphone Sensitivity: -40±2 dB Directivity: Onmi-directional Response Frequency: 50 Hz~16K Hz Response Frequency Signal-To-Noise Ratio 100 Hz~15K Hz More than 60dB Receiver Output Impedance 2. 2K Ohm Operating Voltage LCD DC 5V (Bus-Powered / 5V DC jack) Resolution: 128x64 pixels Size: 59 x 65. 4 mm Backlight: White Multiple languages display Temperature Operating: 0~40 °C Storage: -20~60 °C Storage: < 95% Humidity (Non-Condensing) Operating: < 90% *Specifications are subject to change without notice. 33 TVP-SP2 User's Guide 8. Regulatory Compliance FCC Conditions This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received. [. . . ]