User manual TRENDNET TW100-BRF214

[. . . ] TRENDnet User's Guide Cover Page TRENDnet User's Guide Table of Contents Allow FTP connections using an FTP Non-standard port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Allow NetMeeting H. 323 connections through your router . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Allow/deny ping requests to your router from the Internet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Identify your network on the Internet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Setup DynDNS service (See DynDNS section). Access TRENDnet IP Camera management page and forward Port 80 (see product documentation) 3. Make sure to configure your network/IP camera to use a static IP address or you can use the DHCP reservation feature (see "Set up DHCP reservation" on page 20). Note: You may need to reference your camera documentation on configuring a static IP address. Log into your router management page (see "Access your router management page" on page 16). Click on Advanced Setup and click on NAT, then click on Virtual Server. Click Enabled to turn on the virtual server. Next to Private IP, enter the IP address assigned to the camera. (use the last IP address number such as 192. 168. 10. 101) 8. For the Private Port, enter the port number 80 9. For Public Port, select the Type as TCP and enter the port number 80. 10 Next to Comment, you can enter a comment for the virtual server to make it more easily identifiable. Click Add to add the virtual server to the list. TW100-BRF214 11. Click Apply at the bottom of the page to apply the changes. After the settings have been applied, click Continue on the following page. Note: If you would like to discard the changes, click Cancel before you click Apply. Port Mapping Advanced Setup > NAT > Port Mapping The Port Mapping function is similar to the virtual server function except you cannot specify a different public port and private port (also known as port redirection). The ports you specify in Port Mapping are set to be the same for both public and private ports. Also, in the port mapping section, would will be able to specify multiple ports per entry instead of one port per entry. Log into your router management page (see "Access your router management page" on page 16). Click on Advanced Setup and click on NAT, then click on Port Mapping. Review the port mapping settings. © Copyright 2012 TRENDnet. 28 TRENDnet User's Guide · · · Enabled ­ Checking the Enabled option turns on the port mapping and unchecking the option turns off the port mapping. [. . . ] TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product by any unauthorized service center. This warranty is voided if (i) the product has been modified or repaired by any unauthorized service center, (ii) the product was subject to accident, abuse, or improper use (iii) the product was subject to conditions more severe than those specified in the manual. [. . . ]