User manual TRIANGLE METEOR 0.1 TC

[. . . ] Moving the unit: Always disconnect the power supply cable and the cables between any other audio components when moving the unit. This is in order to prevent any short-circuiting or damage to plugs and connection cables. Before switching the unit on: Check once again that all connections are correct and that volume buttons are at a minimum. Places to avoid: Avoid placing your enclosure near damp areas or areas exposed to excessive sunlight and install it in a cool place. [. . . ] However, do not place it against the television set as the speaker is not shielded. This subwoofer can be used with any type of speaker. The ideal setting should correspond to a realistic reproduction of the basses and be as much in tune as possible with your main loudspeakers. It should not be possible to «feel» the subwoofer, the bass should seem to come from the main speakers. The phase inversion switch can be used to search for the best results. This switch is used to inverse the phase of the sound signals coming from the subwoofer. 19 Depending on the position of the subwoofer in the room in relation to the main speakers, inverting the subwoofer phase can lead to better coherence of the system’s global response to bass frequencies. We recommend you carry out various tests to find the setting which suits you best. Use a recording you know well and study the result according to your tastes and expectations. Using the subwoofer’s internal filtering: The frequency is tuned to the main speakers using the «LOW PASS» potentiometer. The adjustment is made in the frequency range between 40Hz and 160Hz. Carry out tests by first positioning the setting switch between 40 and 80 Hz with large size main speakers, between 80 and 160 Hz for small size speakers. Using the A/V amplifier’s filtering: You can use your A/V amplifier (if it allows) to filter the bass frequencies of the subwoofer. position the volume button at ¾. Make the settings on your A/V amplifier (see the owner’s manual of your equipment at the section setting subwoofer mode and the crossover frequency). Use the LFE input (yellow RCA input) on your subwoofer. In this way, the signal no longer passes through the subwoofer’s internal filter, but directly to the amplifier. 20 USING OF REMOTE CONTROL With the remote control, you can turn on or turn off, control volume and frequency cut. [. . . ] 22 Never open the subwoofer for risk of electrical shock. Only replace a damaged power fuse with a fuse of identical specifications. TECHNICAL SPECIFICATIONS Speaker diameter Total bandpass Filter cutoff frequency6 pts RMS amplifier output Phase Inputs Output Magnetic shielding Dimensions (HxWxD) Weight SUBWOOFERS 210mm 35-160 Hz 40/160 Hz 100 W 0 - 180° L&R high and low level High Level No 370x320x340 14, 5 Kg EN CAS DE PANNE For any further information concerning your system, please consult our website : www. This warranty takes effect from the date of purchase and covers any manufacturing defect or damage your loudspeaker may suffer as a result of these same defects. [. . . ]