User manual TRICITY AW460W

[. . . ] Care should be taken when · · · · · moving it. It is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] If required, press the "low heat" Button. Press the Start Button: the machine starts operating. The "mains on" light comes on. The drum turns alternately in both directions during drying. All drying programmes end with a 10 minute cooling phase (position on selector dial). The machine stops automatically at the end of this phase (knob pointer on position "O"). Immediately remove the laundry. 7 Hints & Tips on Drying Before placing articles of laundry in your tumble dryer, check the care labels to ensure they are recommended for tumble drying. Care Labels you may find on your laundry may be tumble dried normal drying (high temperature) delicate drying (low temperature) do not tumble dry Do not overload the appliance. Here is a list of the approximate weight of some common laundry items. Sheet 700 to 1000 g Pillowcase 100 to 200 g Tablecloth 400 to 500 g Table Napkin 50 to 100 g Kitchen Towel 70 to 120 g Linen Hand Towel 100 to 150 g Hand Towel 150 to 250 g Bath Towel 700 to 1000 g Bathrobe 1000 to 1500 g Shirt 200 to 300 g Apron 150 to 200 g · Always load well spun laundry. The higher the spin speed the lower the electricity consumption and the shorter the drying time. Before contacting your local Service Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom The tumble dryer does not start Possible causes · The door(s) has(have) not been closed. · The plug is not properly inserted in the power socket. · There is no current at the socket. · The main fuse or the fuse in the plug has blown. · The selector dial is not set correctly. · The Start Button has not been depressed. · The water reservoir is full or not properly inserted (the pilot light "full tank" is on ). Drying takes too long or laundry is not dry enough. · The laundry has not been spun properly. · The filters and/or the condenser are clogged up. · The water reservoir is full or not correctly inserted. · The room temperature is too high. [. . . ] The instructions are supplied with the kit. Please contact your Local Service Force Centre for further advice. P1148 P1106 Should the appliance be moved, it must be transported vertically. Door reversal To make it easier to load or unload the laundry the door can be reversed. This operation must be carried out by qualified personnel. Please contact the nearest Service Force Centre. Positioning It is recommended that, for your convenience, the machine is positioned close to your washing machine. [. . . ]