User manual TRICITY BL493W

[. . . ] . Setting the temperature . Health and safety guidelines . . Maintenance and cleaning Internal cleaning . . What happens if something goes wrong?. Tricity Bendix Service Centres . TECHNICAL SPECIFICATIONS POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY GROSS CAPACITY NET CAPACITY 220-240 V / 50 Hz 110 W 0. 80 kWh 155 l 153 l 2 WARNINGS IT IS MOST IMPORTANT THAT THIS INSTRUCTION BOOK SHOULD BE RETAINED WITH THE APPLIANCE FOR FUTURE REFERENCE. [. . . ] The cover/carrier is indicated by the coloured insert at the base of the plug. 6 Location This appliance is designed to be built-in to a space having the dimensions given in Fig. 2 820 870 Door reversibility Remove the two screws which fix the upper hinge to the door. Carefully lean the appliance on its back and remove the plastic insert (Fig. 4 600 547 550 820-870 59 6 100-170 The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 3 D447 Remove the two screws which fix the lower hinge to the door. Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself. Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 5), and, using the screws removed from the lower part, fix it to the base of the appliance itself. Remove and refit the other hinge on the upper part of the appliance on the opposite side. Fix the two front screws into the upper and lower hinges (Fig. 13 D 820 870 170 220 600 D472 135 185 9 If the base plate is between 100 and 135 mm high, cut it as shown in Fig. If the base plate is between 135 and 170 mm high, cut it as shown in Fig. 14 820 870 100 150 20÷ 80 If the appliance has been fitted into a space 870 mm high and the maximum height of the base plate is 150 mm, fit the front cover plate as described in Fig. If the base plate is between 150 and 185 mm high, cut it as shown in Fig. If the base plate is between 185 and 220 mm high, cut it as shown in Fig. 15 820 870 100÷135 150÷185 10 YOUR APPLIANCE G F E D C A B A - Dairy compartment B - Shelf with egg trays C - Bottle storage shelf D - Salad drawers E - Glass shelf (for storing meat) F - Storage shelves G - Thermostat control 11 OPERATION Setting the temperature The temperature inside the refrigerator is regulated by a thermostat with 6 temperature positions and one «OFF» (O) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat dial to the required position; the intermediate position is usually the most suitable (3-4). The thermostat setting can vary as the temperature inside the refrigerator compartment depends on the following factors: ­ room temperature ­ how often the door is opened ­ how much food is stored ­ position of the appliance Important If the fridge is not defrosting correctly, it is possible that because a very low temperature has been selected, the motor is working continuously, which prevents the defrost cycle from operating. To ensure correct defrosting, a lower number should be selected on the thermostat and you should notice that the motor cuts out from time to time, which is correct. If you wish to return to a lower temperature, turn the thermostat to a higher number; however you should turn the setting lower occasionally to allow automatic defrosting. 12 HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been removed from many pre-prepared food. Do not cover the shelves with any protective material, such as paper, cardboard or plastic, which may obstruct the air circulation through them. [. . . ] Has the door been left open causing the temperature to rise?If, after the above checks, there is still a fault, call your local Tricity Bendix Service Centre, whose address can be found in the accompanying Customer Care Booklet, and can also be found in your local telephone directory under «Z». Please make sure you give the model and serial number of the appliance. This information can be found on the rating plate inside the fridge compartment on the left side behind the salad drawer, or on the guarantee certificate. [. . . ]