User manual TRICITY CH611W

[. . . ] 7 Customer Care Department . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Before Calling a Service Engineer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 TECHNICAL SPECIFICATIONS DIMENSIONS Width Height Depth cm 52 cm 15 cm 28. 4 WEIGHT Gross Net kg 5. 5 kg 4. 5 ELECTRICAL CONNECTION Voltage (~50Hz) Fan Lamp Consumption 220-240 V 110 W 40 W 150 W PERFORMANCE Speed Capacity m3/h Capacity lt/sec Pressure mmH2O Noise level dbA 1 120 33 11 47 2 170 47 19 54 3 230 64 26 62 2 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. [. . . ] This cooker hood has been designed for installation over an electric hotplate with a maximum input of 7Kw or a gas hotplate with a maximum input of 10Kw when fitted in accordance with the height recommended in this booklet. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by an inexperienced person may cause injury or more serious malfunctioning. Refer to your local Tricity Bendix Service Centre. Always insist on genuine Tricity Bendix spare parts. GENERAL INFORMATION This Instruction book applies to the following models: Tricity Bendix CH550B Brown 52cm Tricity Bendix CH611W White 52cm This cooker hood is guaranteed and will give lasting service. The guarantee is only applicable if the hood has been installed in accordance with the installation instructions detailed in this booklet. This cooker hood has been designed for use fixed beneath a wall cabinet or purpose built canopy as illustrated in fig. 6 and should be installed in accordance with the following fitting instructions. The hood can be used to extract odours to the outside or to recirculate the air within the kitchen after passing the contaminated air through a (optional) cleansing charcoal filter. The installation instructions which follow give instructions on how and where this hood may be fitted. If already installed check with the installer that all the requirements have been met. Remove the screw from the centre of the motor support grille and taking the filter in one hand place it over the support. Insert the screw with the other hand through the hole in the centre of the charcoal filters as illustrated in fig. 2 and finger tighten the screw until the filter fits flush to the diffuser. In the recirculation mode, contaminated air enters the cooker hood and passes through the grease filter and charcoal filter and out into the kitchen as illustrated in fig. When installed in the recirculation mode it will be necessary for the installer to fabricate a chimney from the ducting spigot on the top of the hood to a terminal in the chimney/wall cabinet housing. Fitting IMPORTANT: Before fitting the hood beneath any type of wall cabinet/ canopy housing ensure it is firmly fixed to the wall in accordance with the manufacturers instructions. Care should be taken to check the wall to which the cabinet/canopy is to be fitted for electric cables, water pipes or gas pipes before drilling. If it is necessary to fix the cabinet/canopy to a hollow construction plaster or partition board structure then it must be sufficiently reinforced to be quite rigid in the area of the cabinet/canopy mounting system. Measure the underside of the cabinet/canopy to mark the position for the cut-out as illustrated in fig. The cut-out should measure, width 497mm by depth 261mm. Check the positioning of the holes is correct with the measurements above before making the cut-out. The hood is fixed using the holes located in rim around the cooker hood casing. [. . . ] Do keep heating areas on your hob covered over with pots and pans when using the hob and cooker hood simultaneously. Don'ts Don't leave naked flames under the hood. Don't leave frying pans unattended during use as over heated fats and oils may catch fire. Don't do flambe cooking under this cooker hood. 7 HELP US TO HELP YOU Cont'd BEFORE CALLING A SERVICE ENGINEER We strongly recommend that you carry out the following checks on your appliance before calling a Service Engineer. [. . . ]