User manual TRICITY CH650W

[. . . ] If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type. If other types of flue or appliances are fitted ensure that there is an adequate supply of air WARNINGS to the room. All installations must comply with the local authorities requirements for the discharge of exhaust air. If the hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety (Installation & Use) Regulations 1994 No. 1886 and the relevant building regulations. [. . . ] This enables the cooker hood when installed in the extraction mode, to be converted to recircu-lation during the winter months. The installation instructions which follow give instructions on how and where this hood may be fitted. If already installed check with the installer that all the requirements have been met. If not then draw these to the attention of the installer who should be a qualified electrician or a competent person. Tricity Bendix disclaims all liability for any damage or injury caused as a result of not following the instructions contained in the following text. Width: CH650W - CH520W 498mm Width: CH610B - CH610W 598mm 3 INSTALLATION UNPACKING Care should be taken when unpacking the cooker hood to ensure that the fixing kit, ducting spigot, blanking plate and literature pack are retained with the hood. The fixing kit comprises: 1- Wall/Suspended fixing template. 2- Security nuts. INSTALLATION brackets. The hood must not be fitted using the key hole fixing points but with the special brackets supplied. Use the paper template provided to mark the hole positions on the wall for the bracket fixing screws. Check the hole distances are correct with a tape measure as stated on the template. At this stage it is important to allow 15mm (1/ 2") clear space above the cooker hood to enable it to be hooked onto the brackets and for subsequent removal for decorating or servicing. A pad saw or similar cutter will be required to cut the circular hole for the ducting spigot if it is to be used. Insert the fixing screws through the holes from inside the cabinet. Supporting the cooker hood tighten each screw about half way to ensure that the cooker hood is correctly positioned before fully tightening the screws. OPERATING INSTRUCTIONS The cooker hood functions are controlled by two slide switches and a change-over slider control. The two slide switches, which are located on the right hand side in the front fascia panel, control the fan speed and worktop illumination. The change-over slider control is located inside the hood behind the inlet grille immediately in front of the lamp assembly. Ensure the hood is in, or wired in and the power supply is switched on. The switch marked with the lamp symbol and numbered 0-1 controls the worktop lighting. Position -1 indicates the light is operating. The switch marked with the fan symbol and numbered 0-1-2-3 controls the fan speed, -1 Low, -2 Normal and -3 Boost. Position -1 Should be selected when simmering or when using one pan. Position -2 Should be selected for normal cooking up to four pans. [. . . ] The telephone number and address for service is detailed on the list headed `Tricity Bendix Service Centres'. PLEASE NOTE that all enquiries concerning serv-ice should be addressed to your local Customer Service Centre. We strongly recommend that you carry out the following checks on your appliance before calling a Service Engineer. it may be that the problem is a simple one, which you can solve yourself without the expense of a Service call. If our Service Engineer finds that the problem is listed below you will be charged for the call whether or not the appliance is under guarantee: - Make sure the appliance is properly wired in and that the Connection Unit is switched "ON". [. . . ]