User manual TRICITY DW120

[. . . ] You MUST read it carefully before installing or using the appliance. If you are unsure about any aspect of the information in this book, please contact our customer care department on 08705 950 950 Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] If you decide to turn back to the use of the standard detergent system we advise that you: q q Refill both the salt container and rinse aid dispenser. Switch the water hardness setting to the highest possible position and run from 1 to 3 normal washing programmes without a load. Readjust the water hardness setting again according to the hardness of the water in your area. Combi detergents If you are using dishwasher detergent that includes the rinse aid function, this must be placed in the detergent compartment. In this case the rinse aid dispenser must be empty, in order to avoid a double dosage. If in the rinse aid dispenser there is still rinse aid you must wait until it has finished before using these kind of detergents. q NOTE: When using dishwasher detergents with integrated and combined detergent/rinse-aid functions, the refilling of the rinse aid dispenser is no longer necessary. Special salt for dishwasher must still be used. In this case the rinse aid indicator light will always remain illuminated when the machine is switched on (not all dishwasher models are foreseen with rinse aid indicator light). NOTE: When using dishwasher detergents with integrated and combined detergent/rinse-aid/salt functions, the refilling of the salt container and the rinse aid dispenser are no longer necessary. In this case the salt and the rinse aid indicator lights will always remain illuminated when the machine is switched on (not all dishwasher models are foreseen with salt and rinse aid indicator lights). 11 Washing programmes Programme Degree of soil and type of load Position of the programme selector dial Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Power Wash 70°C Heavy soil. Crockery, cutlery, pots and pans 1 Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying Cold prewash Main wash up to 65°C 2 warm rinses 1 hot rinse Drying Main wash up to 60°C 1 hot rinse 75 - 85 1, 5 - 1, 7 18 - 20 Normal Wash 65°C Normal soil. Crockery and cutlery 2 105 - 115 1, 3 - 1, 5 20 - 25 (1) Quick Wash 60°C (2) Eco Wash 50°C Fresh soil. Crockery and cutlery 3 25 - 30 0, 7 - 0, 8 8 Normal soil. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. 5. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. To interrupt a washing programme in progress Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. To cancel a washing programme in progress Press the start/cancel button for about 5 seconds. The start/cancel indicator light turns off and the phase indicator lights are flashing. The running programme has been cancelled and it is now possible to set a new washing programme. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. 13 Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. [. . . ] To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. [. . . ]